User manual GAGGENAU AL400121

[. . . ] Keep children below the age of 8 years old at a safe distance from the appliance and power cable. This appliance is not intended for operation with an external clock timer or a remote control. Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as room air-dependent heat-producing appliance is being operated. Gas, oil, wood or coaloperated heaters, continuous flow heaters or water heaters) obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open air through an exhaust gas system (e. [. . . ] – 1 2 3 4 Switch for retracting/extending Lighting Control panel Filter cover Air recirculation The air which is drawn in is cleaned by the grease filters and an activated carbon filter, and is conveyed back into the kitchen. Control panel All function selection buttons are lit when they are active. note: To bind odours in air recirculation mode , you must install an activated carbon filter. The different options for operating the appliance in air recirculation mode can be found in the brochure. The required accessories are available from specialist retailers, from customer service or from the Online Shop. @ Light on/off œ Saturation indicator ž Run-on function Ž Intensive setting 3 Fan speed 3 2 Fan speed 2 1 Fan speed 1 ÿ Fan on/off 18 Installation accessories AA 010 410 AD 754 045 AD 854 043 Air exhaust grille, circulated air, 90 mm Connecting piece for aluminium flexible tube 2 x NW 150 mm, round Connecting piece for flat duct system with guidance fins 1 x NW 150 mm, flat Connecting piece for flat duct system with guidance fins 2 x 2NW 150 mm, flat Extending the appliance 1 2 Remove any objects from the area of movement of the appliance. AD 854 045 Operating the appliance This appliance only works when it is completely extended. Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. Never reach into the moving area of the appliance while it is being retracted or extended. Cookware set down within the movement area of the appliance can fall over. Do not set down any cookware within the movement area of the appliance. Note: Noises may be generated when pulling out and pushing in the appliance. Setting the fan Switching on Three ventilation settings and an intensive setting are available for extraction. Use buttons 1, 2, 3 or Ž the ventilation setting to adapt the setting to the cooking situation. 19 Intensive setting You can use the intensive setting if there is a large build-up of odours and fumes/vapours. Once this time has elapsed, the appliance switches back to the previously selected fan setting. Lighting The lighting can be switched on and off independently of the ventilation. Setting the brightness Press and hold the @ button until the desired brightness is reached. Saturation display After an operating time of 30 hours, the saturation indicator œ for the grease filter flashes. – Run-on function Switching on The run-on function can be activated for any fan setting. If the lighting is switched on, it remains on once the run-on time has elapsed. For instructions on how to clean the metal grease filters, please refer to the section Cleaning and maintenance. [. . . ] Check that the network cables of all the appliances are connected The circuit Look in the fuse box and breaker is faulty check that the circuit breakers for all the appliances are in working order One of the com- Call the after-sales ponents in the service appliance has broken 23 -------- After-sales service Our after-sales service is there for you if your appliance needs to be repaired. We will always find the right solution in order to avoid unnecessary visits from a service technician. The rating plate containing these numbers is found on the underside of the front of the appliance. To access this, open the door of the cupboard in which the appliance is fitted. [. . . ]