User manual GAGGENAU AW 201

[. . . ] Tips and hints in the chapter entitled "Cleaning and care" will make sure that your appliance will stay operable and beautiful for a long time. Important notes 1. 1 For your safety ­ Damaged appliances must not be operated. ­ The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. ­ Connecting cables must not come into contact with hot cooking surfaces. [. . . ] 3 1. 2 Operating for the first time Before operating the appliance for the first time, please pay attention to the following notes: ­ The appliance must be installed and connected by a specialist before it is operated for the first time. ­ Conscientiously read through the operating and assembly instructions before operating the appliance for the first time. ­ Remove the packaging from the appliance and dispose of it properly!Pay attention to the fact that there are accessories in the packaging!­ Thoroughly clean the appliance before using it for the first time (see chapter "Cleaning and care"). ­ Before operating the appliance for the first time, check that the mains connection is in proper working order. 1. 3 About use ­ The appliance is intended solely for use in the household and must not be put to any other uses. ­ In the event of malfunctions, first of all check the household fuses. If the problem has nothing to do with the power supply, please contact your specialist dealer or your local Gaggenau aftersales service. 4 2. Features 1 Ventilation duct 2 Control panel 3 Grease filters (2 grease filters for 70 cm hood, 3 grease filters for 90 cm hood) 1 2 4 Lighting 3 Fig. 2 4 Installation accessories for exhaust air mode Stainless steel-design ventilation duct: LK 010-012 for ceiling heights of 2. 25 - 2. 64 m LK 010-022 for ceiling heights of 2. 64 - 3. 03 m Aluminium-design ventilation duct: LK 011-012 for ceiling heights of 2. 25 - 2. 64 m LK 011-022 for ceiling heights of 2. 64 - 3. 03 m Grease filter saturation display Lighting Run-on Extraction level intensive Extraction level 3 Extraction level 2 Extraction level 1 Motor off Installation accessories for circulating air mode Stainless steel-design ventilation duct: LK 010-112 for ceiling heights of 2. 36 - 2. 64 m LK 010-122 for ceiling heights of 2. 64 - 3. 03 m Aluminium-design ventilation duct: LK 011-112 for ceiling heights of 2. 36 - 2. 64 m LK 011-122 for ceiling heights of 2. 64 - 3. 03 m Fig. Operation After they have been pressed, all functions selection keys except 0 ("Motor off") are backlit in green. Light The lighting can be switched on or off, regardless of whether the wall extractor is in operation, by pressing the key (see Fig. When you briefly press the key, the lighting is increased up to the maximum level. You can dim the lighting to the required level by keeping the key pressed. Fig. 4 Fan levels Three fan speeds and one intensive speed are available (see Fig. You set the fan level required for each respective cooking situation by pressing the function selector keys 1, 2, 3 or Int. or or or Fig. 5 6 The Int key for the intensive level should be pressed when browning and frying in an open pan (see Fig. If you have switched on the hood by selecting the intensive level, it will be switched off again automatically after 5 minutes. Fig. 6 If you press the Int key while the hood is running at fan level 1, 2 or 3, the electronic control will switch back automatically to the previously selected fan level after 5 minutes (see Fig. 7 If you would like to end the intensive level before the five minutes have elapsed, press the 0 key ("Motor off") or select a different level (see Fig. It is possible to switch off the extraction function at any time by pressing the 0 key (motor "off"). Fig. 8 7 Special functions: Intensive time: You can set the intensive level running time to 3, 5 or 10 minutes by simultaneously pressing the Int key and the 1, 2 or 3 key and you can store this setting (see Fig. [. . . ] If no activated charcoal filter is installed, kitchen smells will not be eliminated. Replacing the activated charcoal filter: remove the stainless steel grease filters. Push in the clips on the side of the activated charcoal filter and remove the activated charcoal filter downwardly. Activated charcoal filters (KF 001-010) are available through your specialist dealer. [. . . ]