User manual GAGGENAU AW480180

[. . . ] Regulate the flame in such a way that it does not project over the cooking utensil. For safety reasons, do not place any heavy objects on the top of the appliance. Do not clean the appliance with a steam cleaning apparatus or with water pressure because this poses a risk of short-circuits. Isolate the appliance from the mains during every maintenance operation. [. . . ] Thoroughly clean the appliance before using it for the first time (see chapter "Cleaning and care"). Before operating the appliance for the first time, check that the mains connection is in proper working order. This appliance is labelled in accordance with the European Directive 2002/96/EG concerning used electrical and electronic appliances (waste electrical and electronic equipment ­ WEEE). The guideline determines the framework for the return and recycling of used appliances as applicable. Check the appliance for transport damage before installing it. About use The appliance is intended solely for use in the household and must not be put to any other uses. If the problem has nothing to do with the power supply, please contact your specialist dealer or your local Gaggenau after-sales service. 5 Features of your new appliance Wall ventilation hood AW 480 Ventilation duct Control panel Lighting Grease filters Control panel Grease filter saturation display Lighting Delayed shut-off Extraction level intensive Extraction level 3 Extraction level 2 Extraction level 1 Motor off 6 Accessories Special accessories You can order the following special accessories: · AA 480-180: Activated carbon filter Accessories for installation You can order the following accessories for installation: Installation accessories for exhaust air mode: · · · · AD 480-012 for ceiling heights of 2. 30 ­ 2. 70 m AD 480-022 for ceiling heights of 2. 60 ­ 3. 00 m Installation accessories for circulating air mode: AD 480-112 for ceiling heights of 2. 30 ­ 2. 70 m AD 480-122 for ceiling heights of 2. 60 ­ 3. 00 m 7 Operation After they have been pressed, all functions selection keys except 0 ("Motor off") are backlit in green. Light The lighting can be switched on or off, regardless of whether the wall extractor is in operation, by pressing the key. When you briefly press the key, the lighting is increased up to the maximum level. You can dim the lighting to the required level by keeping the key pressed. Fan levels Three fan speeds and one intensive speed are available. You set the fan level required for each respective cooking situation by pressing the function selector keys 1, 2, 3 or Int. or or or The Int key for the intensive level should be pressed when browning and frying in an open pan. If you have switched on the hood by selecting the intensive level, it will be switched off again automatically after 5 minutes. 8 If you press the Int key while the hood is running at fan level 1, 2 or 3, the electronic control will switch back automatically to the previously selected fan level after 5 minutes. If you would like to end the intensive level before the five minutes have elapsed, press the 0 key ("Motor off") or select a different level. It is possible to switch off the extraction function at any time by pressing the 0 key (motor "off"). 9 Special functions Intensive time You can set the intensive level running time to 3, 5 or 10 minutes by simultaneously pressing the Int key and the 1, 2 or 3 key and you can store this setting. After these ten minutes, the ventilation switches off, but the lighting stays on. or or or Interval ventilation Interval ventilation is a special feature of this appliance which periodically activates the fan for five minutes every hour. You can activate this function by simultaneously pressing the 0 key and, depending on the required extraction capacity, the 1, 2 or 3 key. This mode of operation is indicated by alternating illumination of the key together with the corresponding fan level indicator. You can switch off interval ventilation by pressing the 0 key. or or 10 Cleaning and care Cleaning the grease filters The grease filter saturation display F flashes after an operating time of 30 hours to you indicate to you that you should clean the grease filter. The grease filters can of course be cleaned at any time, even if the grease filter saturation display has not started to flash. 1 2 The stainless steel grease filters can be removed easily for cleaning: Disconnect the power supply (switch off the fuse). [. . . ] They can be disposed of through the household refuse collection. 1. Cleaning the extractor hood Clean the exterior of your extractor hood with a soft cloth and mild detergent solution. Do not use any abrasive sponges or brushes either. 12 Maintenance Disconnect the appliance from the mains before carrying out any repairs. If the power supply is in proper working order, but the appliance is nevertheless not functioning, then please contact your specialist dealer or Gaggenau after-sales service. [. . . ]