User manual GAGGENAU DF 241-161

[. . . ] Gaggenau Operating instructions Dishwasher DF 240-161 DF 241-161 W3126_A (AU) (Ref. 9000 388 730 (8807) en) en Index 4 4 4 4 4 4 4 4 5 5 5 5 5 6 6 6 6 7 7 7 7 7 7 7 8 8 8 8 8 8 9 9 11 11 11 12 12 12 12 12 12 Washing the dishes . Optical display while the programme is running Remaining running time display . 12 12 12 12 13 13 13 13 13 13 14 14 14 14 15 15 15 15 16 16 16 16 16 17 17 18 18 18 19 19 19 19 19 19 20 20 20 20 20 Safety instructions . [. . . ] The LED for button A flashes and the digital display displays the factory setting . Press programme button A until the factory set value is indicated on the digital display 3 . To change the setting: By pressing the C button, you can switch the or on . Close the door. End of programme The programme has ended when the value is indicated on the numerical display 3 . Hold down programme button A and press START button 10 until on the digital display is indicated. The LED for button A flashes and the digital display displays the factory setting . Press programme button A until the factory set value is indicated on the digital display . Each time the button is pressed, the set value has increases by one level; when the value of (off). been reached, the display jumps back to Press START button 10 , the set value is saved. Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Remove the utensils when they have cooled down. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display 3 . The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Timer programming You can delay the start of the programme in 1-hour steps up to 24 hours. Press 8 + or ­ button until the displayed time corresponds with your requirements. To delete timer programming, press the 8 + or ­ is indicated on the digital display 7 . button until You can change your programme selection at any time until the programme starts. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. Close the door. 13 Terminating the programme (Reset) Open the door. Close the door. Interior light * 20 Changing the programme When the START button 10 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. Hold down programme button A and press START button 10 until on the digital display is indicated. [. . . ] Only this extension which features the guarantees compliance with the currently valid regulations. Waste-water connection The required work sequence can be found in the installation instructions. Connect the waste-water hose to the drainage connection of the siphon with the enclosed parts. Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out! Removing the appliance Also observe the sequence of worksteps here. Pull out the appliance, carefully pulling the hose behind. 19 Transportation Empty the dishwasher and secure loose parts. [. . . ]