User manual GAGGENAU DF291160

[. . . ] Operating instructions Dishwasher DF 290 DF 291 DI 290 DI 291 9000 126 064 (8601) en en Index 4 5 6 7 8 8 9 10 12 13 serve@Home * . . Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Please dispose of packaging material properly. In daily use Warning Knives and other utensils with sharp points must be placed in the baskets either flat or with the points downwards. Use the dishwasher only in the household and only for its designed purpose, i. e. [. . . ] If the option "Remote Options" is selected, the message "Enrol Device" will be displayed. After successfully enrolling the device the message "Auto Wash" will be displayed. If the enrolment is unsuccessful the display shows "no gateway found". ** Only with installed interface Remote Control** After choosing the option "Remote Control" the display will show "Remote Control: Off" (factory setting) You activate this option by selecting "Remote Control: On". ** Only with installed serve@Home interface Reduce Time The Auto Programmes allow you to reduce the run time of the programmes. However, in order to achieve an optimal cleaning result, the water and energy consumption will be increased. If the option "Reduce time" is chosen the display shows "Reduce time: Off" (factory setting). Return to the Main Menu by pressing M/OK 2 and start the required programme by pressing the Start Button 4 . If you do not want to use "Reduce time" the next time you use the dishwasher, you must deselect this option. From the Main Menu you can select the following options/settings by repeatedly pressing the button M/OK 2 : Timer programming Remote Control** Reduce Time Drying Level Buzzer Volume Adding Rinse Aid Water Hardness Language Standard Programmes Remote Setting** ** Only with installed interface Within an option/basic setting there are several possible settings that can be selected using the buttons ­ or + 3 . A selected setting is applied by changing to the next option/basic setting using the button M/OK 2 . If a setting has been changed using the buttons ­ or + and stored using M/OK 2 , the message "Value Stored" will be displayed and the display returns to the Main Menu. Drying Level If the option "Drying Level" is chosen the display shows "Normal drying" (factory setting). Alternatively you can select "Eco drying" or "Extra drying". The option "Extra drying" increases the temperature during rinsing in all programmes. (Please take care with delicate dishes. ) Buzzer Volume You can vary or even completely switch off the volume of the acoustic end-of-programme signal. If the option "Buzzer Volume" is chosen the display shows "Buzzer 6" (factory setting). You can change this value to 0 (acoustic signals switched off) or to values between 1 (quiet) and 6 (loud). A short buzz demonstrates the currently chosen volume level. Adding Rinse Aid You can set the amount of rinse aid added. If the option "Adding Rinse Aid" is chosen the display shows "Rinse Aid 4" (factory setting). Change this setting only if there are streaks (reduce the value) or water stains (increase the value) remaining on the dishes. You can choose a value between 0 and 6. Timer programming You can delay the programme start by 24 hours in steps of 30 minutes. If the option "Time Pre-select" is chosen the display shows "Delay start: 00 mins". Return to the Main Menu by pressing M/OK 2 and start the required programme by pressing the Start Button 4 . Until the programme starts you are able to change the set time and programme. [. . . ] When replacing the appliance, always connect a new water supply hose to the water supply. Water pressure: Minimum 0, 05 MPa (0, 5 bar) ­ maximum 1 MPa (10 bar). If you do use hot water, the temperature should not exceed 60 °C. Protection from freezing temperatures If the appliance is installed in a location where there is a risk of freezing temperatures (e. g. in a holiday home), all water must be completely drained out of the interior (see "Transporting the dishwasher"). [. . . ]