User manual GAGGENAU DI 230 AU

[. . . ] Operating instruction DI 230 130 AU Dish washer 9000 114 500 (8510) aus Index 4 6 6 7 8 12 15 Washing dishes . . aus Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Please dispose of packaging material properly: Built-under and built-in appliances should always be installed under a continuous work surface which is attached to the adjacent cupboards, in order to ensure that the appliance is entirely stable. After the appliance has been installed, the mains plug should still be easily accessible. [. . . ] Remove the utensils when they have cooled down. Switching on the appliance Close the door. The programme sequence display 5 lights up, the programme sequence starts automatically. Interrupting the programme Set the main switch 1 to OFF. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. In order to resume the programme, set the main switch to ON again. 16 aus Terminating the programme (Reset) Only when the main switch is on: Rotate programme selector to the Reset position. To restart, rotate the programme selector 3 to the required programme. The programme sequence starts automatically. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. Therefore you should occasionally have a careful look inside your dishwasher. Overall condition of the machine Check spray arm for grease and limescale deposits. If you find such deposits: Fill the detergent dispenser with detergent, start the appliance without utensils in the programme which has the highest wash temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly wipe the front of the appliance and panel with a damp cloth; water and a little washing-up liquid will suffice. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Health hazard! Changing the programme It is possible to change the programme within 2 minutes after you have switched the dishwasher on. Should it be necessary to change the programme after this period, the programme cycle that has already been begun (e. g. Note If the power supply is disconnected while the appliance is operating, e. g. by switching off the appliance or due to a power failure, all settings remain stored. Operation continues automatically as soon as the power supply is restored. Rinse-aid As soon as the rinse-aid refill indicator lights up on the control panel 7 , refill with rinse aid. Filters The filters 24 prevent larger remnants of food or other objects from getting inside the pump. The filter system consists of a filter cylinder, a flat fine filter and, depending on 17 aus the model, a microfilter (*). Inspect the filters for obstructions every time the dishwasher has been used. Reassembly: Insert the filter system and screw down with the filter cylinder. 18 aus Spray arms Lime and remnants of food in the washing water can block the nozzles in the spray arms 22 and 23 and the arm mountings . Inspect the nozzles in the spray arms for blocked holes due to remnants of food. Clean both spray arms under running water. Pump * * on applicable models Larger remnants of food that have not been trapped by the filters and have been left in the water can cause a blockage in the pump. The water is no longer pumped out of the dishwasher and it can be seen covering the filter. [. . . ] If the appliance is not kept upright during transport, any water left inside may seep into the control module and cause subsequent errors with programme functions. Transporting the dishwasher Drain water from the dishwasher. If the appliance is not kept upright during transport, any water left inside may seep into the control module and cause subsequent errors with programme functions. Drain the appliance according to the following steps: Turn on the tap. Turn off the tap. Electrical connection This appliance should only be connected to a 240 V AC source via a properly installed earthed socket. [. . . ]