User manual GAGGENAU DI260130

[. . . ] Gaggenau Operating instructions Dishwasher DI 260 9000 423 799 (8901) en en Index 4 4 4 4 4 4 4 4 5 5 5 5 6 6 6 6 6 7 7 7 8 8 8 8 8 8 8 8 9 9 9 9 10 10 10 10 12 12 12 13 13 13 13 13 13 Washing the dishes . 13 13 13 13 13 14 14 14 14 14 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 19 19 19 20 20 20 20 20 20 20 20 21 21 21 Safety instructions . . Safety instructions Delivery Check the packaging and dishwasher immediately for damage caused in transit. Please dispose of the packaging material in an environmentally friendly manner. [. . . ] If you would no longer like to have this additional information displayed, proceed as follows. Hold down programme button A and press START is button 10 until on the digital display indicated. display displays the factory setting Press programme button A until the factory set is indicated on the digital display 3 . value To change the setting, By pressing the C button, you can switch the onboard computer (additional programme information) off or on . Close the door. End of programme The programme has ended when the value is indicated on the numerical display 3 . Hold down programme button A and press START is button 10 until on the digital display indicated. The LED for button A flashes and the digital display displays the factory setting . Press programme button A until the factory set is indicated on the digital display . Each time the button is pressed, the set value increases by one level; when the value of has (off). been reached, the display jumps back to Press START button 10 , the set value is saved. Close the door. Timer programming You can delay the start of the programme in 1-hour steps up to 24 hours. Press 8 + or ­ button until the displayed time corresponds with your requirements. To delete timer programming, press the 8 + or ­ button until is indicated on the digital display 7 . You can change your programme selection at any time until the programme starts. Close the door. Switching off the appliance Short time after the end of the programme: Open the door. Remove the utensils when they have cooled down. Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. Close the door. 14 Terminating the programme (Reset) Open the door. Close the door. Interior light * 20 Changing the programme When the START button 10 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. [. . . ] Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out! Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: Turn on the tap. The expected programme duration is indicated on the numerical display 3 . (This prevents residual water from running into the machine control and damaging the programme sequence). Fresh-water connection Connect the fresh-water connection to the tap according to the installation instructions with the enclosed parts. [. . . ]