User manual GAGGENAU DI460110

[. . . ] Operating instructions Dishwasher DI 460 DI 461 9000 162 939 (8603) en en Index 4 5 5 6 6 7 9 10 12 Washing dishes . . Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Please dispose of packaging material properly. In daily use Warning Knives and other sharp-pointed utensils must be placed with the points down in the cutlery basket or horizontally in the utensils basket. Use the dishwasher only in the household and only for its designed purpose, i. e. [. . . ] If these conditions are changed, the running time (depending on the selected programme) can vary greatly. As the effect is not detected until a programme is running, the time may be longer or shorter than expected. Time delay * * on applicable models You can delay the start of the programme in 1-hour steps up to 19 hours. Press the timer programming button 3 until the digital display 8 jumps to . Keep pressing the timer programming button until the required time is displayed. To delete the timer programming, keep pressing the button until is displayed. You can change your programme selection at any time until the programme starts. Aqua sensor * * some models The Aquasensor is an optical measuring device (light barrier) which measures the turbidity of the rinsing water. When the Aqua sensor is active, "clean" rinsing water may be transferred into the next rinsing bath and/or the temperature adjusted. If the turbidity is greater, the water is drained and is replaced with fresh water. 4 litres. End of programme The end of the programme is indicated by a buzzer. This function can be changed as follows:­ Hold down Function button C pressed and switch on main switch 1 , then let the buttons go. Function Button C flashes, and the digital display indicates the value which was set at the factory (semi-loud). Each depression of the button increases the set value by one, when is reached, the display jumps back to (off). The set value is stored in the appliance. Switching the dishwasher ON Turn on the tap. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 6 is pressed The numerical display 8 shows the expected duration of the programme. The programme starts automatically. Programme sequence indicator Your dishes are being cleaned. Your dishes are being dried. 9 13 Switching the dishwasher OFF Several minutes after the programme has ended: Open the door when the programme has ended. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. Additional functions * not included with all models Soaking * The soaking cycle runs before the main programme and must be selected before the programme starts. 5 g of detergent on the door. Interrupting the programme Open the door. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. In order to continue with the stored programme, set the main switch to ON again and close the door. Turbo * The programme running time is reduced significantly in the Turbo programme. [. . . ] Turn OFF the tap, disconnect the supply hose and allow to drain. Removing the appliance It is essential, when removing the appliance, to observe the following sequence: First, disconnect the appliance from the power supply. Pull out the appliance, carefully pulling the hose behind. 19 Waste disposal Disposal Old appliances are not worthless rubbish. To prevent children from locking themselves in the appliance and suffocating, destroy the door lock and childproof lock (if fitted). Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. [. . . ]