User manual GAGGENAU DI460111

[. . . ] Gaggenau Operating instructions Dishwasher DI 460 DI 461 9000 407 108 (8811) en en Index 4 4 4 4 4 4 4 4 5 5 5 5 6 6 6 6 6 7 7 7 8 8 8 8 8 8 8 8 9 9 9 9 10 10 10 11 12 12 12 13 13 13 13 13 13 13 Washing the dishes . 13 13 13 13 14 14 14 14 14 15 15 15 15 15 15 16 16 16 16 17 17 17 17 17 18 18 19 19 19 20 20 20 20 20 20 21 21 21 21 21 Safety instructions . . Safety instructions Delivery Check the packaging and dishwasher immediately for damage caused in transit. Please dispose of the packaging material in an environmentally friendly manner. [. . . ] There is a slight increase in the energy consumption. 13 Switching on the appliance Turn on the tap fully. This programme remains selected if no other programme button 2 is pressed. The programme starts running. Timer programming You can delay the start of the programme in 1-hour steps up to 24 hours. display 7 jumps to Press 8 + or ­ button until the displayed time corresponds with your requirements. To delete timer programming, press the 8 + or ­ button until is indicated on the digital display 7 . You can change your programme selection at any time until the programme starts. Close the door. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display 3 . The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). End of programme is The programme has ended when the value indicated on the numerical display 3 . Hold down programme button A and press START is button 10 until on the digital display indicated. display displays the factory setting Press programme button A until the factory set value is indicated on the digital display . Each time the button is pressed, the set value increases by one level; when the value of has (off). been reached, the display jumps back to Press START button 10 , the set value is saved. Close the door. Display window Apart from information on the programme sequence, the display window 12 also indicates additional information on e. g. If you would no longer like to have this additional information displayed, proceed as follows. Hold down programme button A and press START is button 10 until on the digital display indicated. display displays the factory setting Press programme button A until the factory set is indicated on the digital display 3 . value To change the setting, By pressing the C button, you can switch the onboard computer (additional programme information) off or on . Close the door. 14 Switching off the appliance Short time after the end of the programme: Open the door. Remove the utensils when they have cooled down. Intensive drying The final rinse uses a higher temperature which improves the drying result. Hold down programme button A and press START is button 10 until on the digital display indicated. display displays the factory setting Press programme button A until the factory set is indicated on the digital display 3 . value To change the setting, Press the button C to switch intensive drying on or off . [. . . ] Connect the waste-water hose to the drainage connection of the siphon with the enclosed parts. Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out! Removing the appliance Also observe the sequence of worksteps here. Pull out the appliance, carefully pulling the hose behind. 20 Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: Turn on the tap. [. . . ]