User manual GAGGENAU RC 462 200AU

[. . . ] Gaggenau en Operating instructions RC 462. . . AU 2 Table of Contents Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Technical safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fascia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 5 5 5 6 6 6 7 7 7 8 9 Re-arranging the interior . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to a heat source: 3 cm to an electric cooker. To ensure that the ice maker functions correctly, the appliance must be upright. Fixing For secure installation, the appliance screwed to neighbouring kitchen furniture and/or units. The rating plate is situated in the bottom left-hand side of the appliance. The power cord may be replaced by a technician only. Note The factory settings (language, temperature unit) can be changed in the setup mode. m Warning Never connect the appliance to electronic energy saver plugs or to power inverters which convert the direct current to 230 V alternating current (e. g. solar equipment, power supplies on ships). Switching on the appliance Press the on/off button O. The appliance starts to cool down when switched on for the first time. Note The preset temperatures (factory settings) are reached after several hours. To change the set temperatures ­ see "Setting the temperature" (page 12). 11 Selecting the temperature The temperature can be set from +2 ° C to +8 ° C. We recommend a setting of +4 ° C. Motorised shelf The appliance is equipped with a height adjustable motorised shelf. The temperature setting can be changed using the can be set at 1 ° C intervals. To set the temperature: Active the setup mode using the < or > buttons. Set the desired temperature using the + (warmer) or ­ (cooler) setting buttons. + (warmer) or ­ (cooler) setting buttons. The temperature When the toggle switch is set upwards: The shelf moves upwards. Note Maximum motorised shelf load: 10 kg When the appliance is operated, all messages are displayed in fascia in English. Alternatively, the display languages can be selected corresponding to the table on page 16. In order to change the display language: Press setup button The drive cuts out if overloaded in order to avoid damage. Set the language Controlled ventilation You can use the controllable ventilation to set the air humidity in your fruit and vegetable container. W. Press the selection button >, until ENGLISH is displayed. Press the + or ­ setting button, until the desired language is displayed. Slide control to the right: low air humidity Press the setup button W, in order to store the settings. Slide control to the left: high air humidity. 12 Fast cooling In the fast cooling mode, the refrigerated compartment will be cooled for approx. Switch the function on: to cool drinks quickly, before placing large quantities of food in the refrigerator compartment. The u symbol appears in the fascia under super temperature. Chiller section drawer (Special unfrozen compartment) The temperature in this compartment is kept at almost 0 ° C. This provides optimum storage conditions for fresh food. Press the appropriate button (fish, meat/poultry, vegetables) corresponding to the food stored. The selection is displayed by the corresponding LED being illuminated. "Fast cool" function ends: by pressing the fast cooling button 3 again; by activating the eco function; by activating the holiday mode; by activating the sabbatical mode. [. . . ] Remedial action Conduct a self-test on the appliance. Sensor failure Low voltage Warning messages via the display If several warning notices appear at once, see to each warning in turn. When the mains voltage reaches the stipulated value again, the warning message goes out. If the warning message lasts for longer, inform the energy supply company. Cause One door of the appliance has not been closed correctly or has been open too long. The display goes out. 20 Appliance self-test Before you call customer service, conduct a self-test on the appliance. [. . . ]