User manual GAGGENAU RW496250

[. . . ] Gaggenau en Installation instructions RX 492 RW 496 Table of Contents Safety and warning notes . Clearance from the appliance to the handle of the adjacent kitchen unit . Fitting the appliance into the kitchen counter Fitting the kitchen unit doors . 11 11 11 14 15 16 17 18 Setting up the appliance as a free-standing unit (RW496 only) . [. . . ] Loosen the lock nuts on the adjustment spindles of the appliance feet. 9. Remove the bands from the wooden blocks and pull the wooden blocks out. 12 Removing the wooden palette The castors on the appliance feet are guided along guide rails on the wooden palette. There must be a second person supporting the appliance on the other side. 3. There must be a second person supporting the appliance on the other side. 5. Pull the raised side as far away from the wooden palette as possible without pulling the castored feet of the appliance off the wooden palette. The castors could otherwise be damaged and the appliance could tip over. Lower the appliance carefully. 13 3. ! Fitting the anti-tip stabiliser Warning!Until the anti-tip stabiliser has been fitted, the appliance could tip over if the appliance doors are opened. Do not open the appliance doors until the anti-tip stabiliser has been fitted. 5. Slide the anti-tip stabiliser underneath the nuts and onto the threaded bolts. The anti-tip stabiliser must not be removed until the appliance is firmly screwed into its installation location and thereby secured against tipping over. Turn the nut on the adjustment spindle upwards until the castor is firmly on the floor. 2. 2. 14 4. Connecting the appliance to the mains The socket must be freely accessible and must not be behind the appliance. Route the power cord in such a way that it cannot be run over or trapped when the appliance is moved into the niche. Socket on the right-hand side when viewed from the rear side of the appliance: Remove the cover plate. Following installation, there must be a minimum waiting period of ½ hour before the master switch is switched on. The oil contained in the compressor may have been displaced into the refrigeration system during transport. 15 5. Aligning the appliance 4. Using a spirit level, align the appliance vertically and horizontally. For alignment, the appliance must be standing on a flat surface. Loosen the lock nut on the four adjustment spindles of the appliance feet. ! Warning!The appliance could tip over if any one of the appliance feet is turned in or out too far. Screw the appliance feet in or out little by little one after the other. The castor of the anti-tip stabiliser must also be firmly on the floor. To adjust the height of the appliance: Turn the hexagon on the adjustment spindles until the desired height is reached. [. . . ] Position the angle brackets over the marked positions and mark the drilling points. 21 9. Removing the anti-tip stabiliser 10. Unscrew the nuts from the angle brackets and remove them along with the washers. The anti-tip stabiliser must not be removed until the appliance is firmly screwed into its installation location and thereby secured against tipping over. Slot the anti-tip stabiliser's rear mounting point onto the threaded bolt at the front. The castor must be on the left-hand side. The angle brackets have 5 holes for adjusting depth. [. . . ]