User manual GAGGENAU VC422610

[. . . ] Operating and Assembly Instructions VC 422-610 Glass Ceramic Electric Cooktop VC 422-610 Important safeguards 1. Important Notes For your safety Operating for the first time About use 2. Operation Switching on and off Indicator light / Residual heat display Cooking zone extension Holiday safeguard 4. Installation Technical Data Important notes on installation Electrical connection Preparing the cabinet Installing the control panel Installing the cooktop Page 3-4 Page 5-6 Page 5 Page 6 Page 6 Page 7-8 Page 7 Page 7 Page 8 Page 9-10 Page 9 Page 9 Page 10 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15-20 Page 15 Page 15 Page 16 Page 17-18 Page 19 Page 20 1 Congratulations on buying your new "Vario" appliance. [. . . ] Do not use the appliance cover as a surface for placing objects or for keeping things warm. Subject to technical change without notice. 5 Operating for the first time Remove the packaging from the appliance and dispose of it according to local regulations. The appliance must be installed and connected by an authorised specialist before operation. Before operating the appliance for the first time, make sure that the mains connection is in proper working order. The serial number of the appliance can be found on the quality control slip which is included with these instructions. This quality control slip should be kept, for guarantee reasons, together with your operating and assembly instructions. Read through these instructions attentively before operating your appliance for the first time. Thoroughly clean the appliance and accessories before using them for the first time. This will eliminate any 'newness' smells and soiling (see chapter "Cleaning and care"). About use The appliance is intended solely for household use and must not be put to any other uses. Do not use the appliance to heat up the room in which it is installed. Place a cooking vessel on the corresponding cooking zone before operating it. Do not remove the cooking vessel until you have switched off the hotplate. The size of pots and pans should correspond to the size of the hotplate. Never heat food in aluminium or plastic containers as the material can melt and damage your hob. Built-in overheating protection prevents overheating of the appliance and of surrounding kitchen furniture. If the power supply is in proper working order, but the appliance is still not functioning, please inform your specialist dealer or your nearest Gaggenau after-sales service. 6 2. Features Features 1 SuperQuick cooking zone Ø 5 3/4 ´ ´ (1100 W), converts to roasting zone 5 3/4 ´ ´ x 9 1/2 ´ ´ (2000 W) 1 2 SuperQuick cooking zone Ø 7 ´ ´ (1500 W), converts to Ø 9 ´ ´ (2400 W) 3 Display panel with indicator light and residual heat display 4 Control knob for front cooking zone 3 4 5 5 Control knob for rear cooking zone 2 Special accessories You can order the following special accessory: VV 400-000 Connecting trim VZ 400-700 Connecting trim with timer VD 400-000 Appliance cover 7 Visual signals Luminous disc Indicator behind the on the control knob cooker lights OFF light constantly slow flashing of indicator light (long OFF short ON) , fast flashing of a luminous disc cooking zone ON residual heat display Signification Cause / Remedy appliance is switched OFF normal use The appliance is too hot to be touched safely. holiday safeguard The appliance setting has not been changed for over 4 hours. power cut After a power cut, the appliance stays switched off for safety reasons. Connecting cable between the appliance and the control panel is not plugged in. Check that cable is plugged in firmly. fast flashing of both control knobs fast flashing of both luminous discs alternately faulty installation 8 3. Operation Switching on Switching on Press down the control knob for the corresponding cooking position and turn it left or right to the required position (1 -12). The luminous disc behind the control knob and the corresponding indicator light on the display panel light up, as long as the corresponding cooking zone is switched on. [. . . ] Rated power consumption: 4 400 W Note: if there is a need for an intermediate cupboard wall under the hob, cut out the recess so that the trough of the hob does not lie on the cupboard side wall and so that a distance of 20 mm (13/16 ´ ´ ) from the intermediate cupboard wall is guaranteed. Please note that a distance of 10 mm ( 13/32 ´ ´ ) from the base cabinet must be observed for safety reasons. (see figure) Only a qualified electrician should install this appliance. The mains connecting cable must at least correspond to the type SJTO 3x16 AWG 105°C. [. . . ]