User manual GAGGENAU VE230934

[. . . ] 9000576480 901129 VE 230 934 ã Ú Installation instructions PLQ PLQ ¡ [ ¡ PLQ PLQ PLQ ko ã 30 mA (RCD) . . en Ú Installation instructions Fitting the appliance 1. Fit the long mounting rail Important notes Read these instructions carefully and keep them in a safe place. [. . . ] Note: when fitting the appliance in a stone worktop glue on the mounting rails with a temperature-resistant two-component adhesive (metall on stone). For combination with the appliance cover VD 201: secure the appliance cover on the appliance before installation (refer to the installation manual of VD 201). The snap-in pins on the appliance must lie exactly on the catch springs. The pins on the appliance must snap into the catch springs. Special instructions for installation outdoors Operate the appliance on a residual current device (RCD) with a maximum tripping current of 30 mA. Attach a suitable plug for outdoor use to the mains cable (observe the respective national regulations). Connect the appliance to an earthed socket (for protection class I appliances). The appliance must be protected from weather after use and cooling down (e. g. with a cover). Preparing the furniture The surrounding kitchen unit must be heat-resistant to at least 90 °C. The stability of the unit must be maintained after producing the cut-out. Observe a minimum clearance between the appliance housing and parts of the unit of 10 mm. Protection against accidental contact from below must be guaranteed after installation. If the underside of the appliance can be touched after installation, an intermediate shelf must be fitted that can only be removed using a tool. Observe a minimum clearance between the appliance and the shelf of 10 mm. When fitting several Vario appliances: allow for the additional space required for the connecting strip VV 200. [. . . ] Recommendation: install a properly earthed socket behind the appliance, approx. Only a qualified electrician who takes the appropriate regulations into account may connect a socket. The appliance corresponds to type Y: the mains connection cable must only be replaced by the after-sales service. [. . . ]