User manual GAGGENAU VE260934

[. . . ] 9000576481 901129 VE 260 934 ã Ú Installation instructions ¡ [ ¡ PLQ PLQ PLQ PLQ PLQ PLQ ko ã . ( , ). en Ú Installation instructions Special instructions for installation outdoors Operate the appliance on a residual current device (RCD) with a maximum tripping current of 30 mA. [. . . ] Observe the minimum distance to side walls or furniture parts and to the rear wall. This appliance is not intended for operation with an external timer or an external remote control. Removing the appliance Disconnect the appliance from the power supply. Do not lever out the appliance from above. Preparing the furniture The surrounding kitchen unit must be heat-resistant to at least 90 °C. The stability of the unit must be maintained after producing the cut-out. Observe a minimum clearance between the appliance housing and parts of the unit of 10 mm. Protection against accidental contact from below must be guaranteed after installation. If the underside of the appliance can be touched after installation, an intermediate shelf must be fitted that can only be removed using a tool. Observe a minimum clearance between the appliance and the shelf of 10 mm. When fitting several Vario appliances: allow for the additional space required for the connecting strip VV 200. Appliances can also be fitted in individual recesses, if a minimum clearance of 40 mm between the appliances is observed. Electrical connection Check the electrical installation system before connecting the appliance. Make sure that the household installation has sufficient fuse or circuit breaker protection. Check that the appliance has the same voltage and frequency as the electrical installation system (see rating plate). The appliance corresponds to protection class I and may only be operated with a protective earth connection. The installation system must incorporate an all-pole isolating switch with a contact gap of at least 3 mm. [. . . ] Note: when fitting the appliance in a stone worktop glue on the mounting rails with a temperature-resistant two-component adhesive (metal on stone). The snap-in pins on the appliance must lie exactly on the catch springs. [. . . ]