User manual GAGGENAU VL 051-107

[. . . ] You will find notes on Page 4 that you ought to observe before operating the appliance for the first time. The chapter entitled "Cleaning and care" will make sure that your appliance will stay operable and beautiful for a long time. Important notes 1. 1 For your safety Damaged appliances must not be operated. The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. [. . . ] Technical modifications reserved. 3 1. 2 Operating for the first time Before operating the appliance for the first time, please pay attention to the following notes: ­ Conscientiously read through the operating and assembly instructions before operating the appliance for the first time. ­ The rating plate for this appliance is included with the instructions on a separate sheet. Store the rating plate in the same location as your operating and assembly instructions. ­ Remove the packaging from the appliance and dispose of it properly. Pay attention to the fact that there are accessories in the packaging. ­ Thoroughly clean the appliance before using it for the first time. (see chapter entitled "Cleaning and care") ­ Before operating the appliance for the first time, check that the mains connection is in proper working order. 1. 3 About use ­ Do not pour any liquids into the tub!If liquid should have inadvertently penetrated into the tub, wipe it out immediately. ­ If the swivel arm gets soiled during operation, clean it before moving it in. 4 2. Structure and operating principle 2. 1 Structure of the appliance 1 Grease filter 1 2 3 2 Lid 3 Swivel arm 4 Tub 5 Control panel 4 5 Fig. 2 2. 2 Control panel 6 "Height adjustment" control knob 7 Grease filter pilot lamp 8 "Power level" control knob with the positions 0, 1, 2, 3, after-running stage and grease filter indication 3 Fig. 3 6 7 8 2. 3 Accessories You can order the following special accessories: VV 200-000: connecting trim AR 070-051: flat Aluflex duct (app. 40 cm long) AS 081-051: attachment plate for GB 031 AS 090-051: 2 deflectors for installation with flat duct 5 3. Operation Switching on ­ Turn the "Power level" control knob to the required position on the right. The boom moves automatically to the frying position, and it can then be extended continuously up to its fully extended position (cooking position) by turning the "Height adjustment" knob. 3 Fig. 4 You can also extend the boom to the required position before switching on the appliance. In the cooking position (height 100-410 mm), the boom can be swivelled manually; its swivel radius depends on its height when extended. If the swivel arm is extended without an output level having been set, as from the roasting position the connected fan module automatically runs at a basic level. Switching off ­ Turn the "Power level" control knob to the 0 position on the left. ­ Turn the "Height adjustment" knob to the left to retract the boom. The boom turns automatically to its defined starting position in the trough. 3 Fig. 5 After-running ­ Turn the control knob to the left to the (Afterrunning) position. [. . . ] ­ Place the two included protective covers on the tube opening to make sure that no small parts will fall into the suction pipe. Only clean the swivel arm after the appliance has cooled down. 8 5. Maintenance First disconnect the appliance from the mains before carrying out any repairs. If the power supply is in proper working order, but the appliance is nevertheless not functioning, then please contact your specialist dealer or your responsible Gaggenau after-sales service. [. . . ]