User manual GAGGENAU VL041707

[. . . ] 2 2 Safety notes Read And Save These Instructions. WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a. ) Use this unit only in the manner intended by the manufacturer. b. ) Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. WARNING - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: a. ) SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. [. . . ] Store the rating plate in the same location as your operating and assembly instructions. ­ Remove the packaging from the appliance and dispose of it properly. Pay attention to the fact that there are accessories in the packaging. ­ Thoroughly clean the appliance before using it for the first time. (see chapter entitled "Cleaning and care") ­ Before operating the appliance for the first time, check that the mains connection is in proper working order. 5 2. Structure and operating principle 2. 1 Structure of the appliance 1 Ventilation grille 2 Control knob (VL 041-707 only) 3 Clamping screw 4 Retaining bracket 5 Suction extraction connection 1 2 2 3 4 5 Fig. 3 2. 2 Accessories Special accessories: AS 070-000: connection piece for extension during assembly (fig. 4 RV 050-150: bifurcated pipe for joining 2 x DN 125 into DN 150 (fig. Operation Note: VL 040 can only be operated in combination with VL 041 or VL 051. That is to say: if you set the control knob to level 1, both hob ventilators are operated at level 1. Switching on Switching on Turn the control knob to the right to the position you require (0-2). Fig. 6 Switching off Switching off Turn the control knob to the left to the 0 position. Fig. Cleaning and care Caution: Avoid sharp and caustic cleaning agents as well as brushes and abrasive cleaners. Use commercially available window cleaner and apply it to a soft, moist cloth. Clean the ventilation grille with a moist cloth and detergent solution. You should not clean the ventilation grille in a dishwasher because spots may appear on the ventilation grille. Grease filter cleaning You can clean the metal grease filters in a dishwasher at a maximum temperature of 65 °C / 150 °F. Place the grease filter in the dishwasher with the opening pointing down to ensure that no food remainders will stay on it. ­ Turn up the two retaining wires and detach the grease filter from the appliance. 8 The grease filters must be cleaned on a regular basis (at the latest after 30 hours of operation). Maintenance The appliance must be disconnected from the power supply during all repair work. If the power supply is functioning correctly, but your appliance still does not work, please contact your Gaggenau dealer who will provide you with the address and telephone number of your nearest manufacturer's authorized service agent or contact Gaggenau USA on (800) 828-9165. [. . . ] Make sure that the contact face of the securing rail lies on the worktop and that the centre marking of the securing rail is precisely flush with the centre marking on the worktop. Fig. Make sure that the engaging lugs on the appliance lie exactly on the clamping springs. The engaging lugs on the appliance "snap" into the clamping springs. ­ Screw the included screw from below into the hooked-in retaining bracket (fig. [. . . ]