User manual GAGGENAU VL051107

[. . . ] You will find notes on Page 4 that you ought to observe before operating the appliance for the first time. The chapter entitled "Cleaning and care" will make sure that your appliance will stay operable and beautiful for a long time. Important notes 1. 1 For your safety Damaged appliances must not be operated. The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. [. . . ] In the cooking position (height 100-410 mm), the boom can be swivelled manually; its swivel radius depends on its height when extended. If the swivel arm is extended without an output level having been set, as from the roasting position the connected fan module automatically runs at a basic level. Switching off ­ Turn the "Power level" control knob to the 0 position on the left. ­ Turn the "Height adjustment" knob to the left to retract the boom. The boom turns automatically to its defined starting position in the trough. 3 Fig. 5 After-running ­ Turn the control knob to the left to the (Afterrunning) position. ­ Turn the control knob to the 0 position if you wish to prematurely end the after-running time. Holiday protection ­ The appliance switches itself off four hours after the last operator action. Cleaning and care Caution: Avoid sharp and caustic cleaning agents as well as brushes and abrasive cleaners. Clean the stainless steel tub with mild rinsing detergent and apply stainless steel care agent to the metal surfaces using a soft cloth. Do not use any cleaning agent as it might be agressive to the inscription markings. Grease filter cleaning The grease filter indication symbol lights up on the operating panel after around 30 hours of operation. Illumination of this symbol signals to you that the grease filters have to be cleaned. You can clean the metal grease filters in a dishwasher at a maximum temperature of 65°C. To do this, place the grease filters in the dishwasher in such a way that it is cleaned completely. Proceed as follows: ­ Turn the "Height adjustment" control knob to the right to extend the boom slightly. ­ Turn the two retaining wires up and remove the grease filter from the appliance. ­ Turn the control knob to the position (grease filter indication). Only clean the grease filter after the appliance has cooled down. 7 Swivel arm cleaning If the swivel arm gets very dirty, it can be dismantled for cleaning. You can clean the swivel arm in a dishwasher at a maximum temperature of 65°C. Proceed as follows: ­ Turn the "Height adjustment" control knob to the right to extend the boom slightly. ­ Turn up the two retaining clips and remove the grease filter from the appliance. [. . . ] Before sawing out the base plate, check whether the depth of the base area is sufficient for the fan module. Fig. 9 0 156 490 Worktop height 90 cm, variable position of the fan module ­ Saw out the base plate in the built-in cabinet for the fan module. 00 min. 5 500 Refer to the operating instructions of the fan module for details of how to install it. ­ Using a flexible aluminium pipe (DN 125), connect the pipe connection piece to the fan module. [. . . ]