User manual GAGGENAU VL051707

[. . . ] Operating and assembly instructions VL 051-707 Automatically extendible hob ventilator 3 VL 051-707 Preface Safety notes 1. Important notes 1. 1 For your safety 1. 2 Operating for the first time 1. 3 About use 2. Structure and operating principle 2. 1 Structure of the appliance 2. 2 Control panel 2. 3 Accessories 3. Assembly instructions 6. 1 Technical data 6. 2 Important notes 6. 3 Electrical connection 6. 4 Installation Page 3 Page 4-5 Page 4 Page 5 Page 5 Page 6 Page 6 Page 6 Page 6 Page 7 Page 8-9 Page 10 Page 11-15 Page 11 Page 11-12 Page 13 Page 14-15 1 Preface With your new hob ventilator, working in the kitchen will be even more fun. [. . . ] The boom moves automatically to the frying position, and it can then be extended continuously up to its fully extended position (cooking position) by turning the "Height adjustment" knob. 3 Fig. 4 You can also extend the boom to the required position before switching on the appliance. In the cooking position (height 100-410 mm / 315/16"-161/8"), the boom can be swivelled manually; its swivel radius depends on its height when extended. If the swivel arm is extended without an output level having been set, as from the roasting position the connected fan module automatically runs at a basic level. Switching off ­ Turn the "Power level" control knob to the 0 position on the left. ­ Turn the "Height adjustment" knob to the left to retract the boom. The boom turns automatically to its defined starting position in the trough. 3 Fig. 5 After-running ­ Turn the control knob to the left to the (Afterrunning) position. ­ Turn the control knob to the 0 position if you wish to prematurely end the after-running time. Holiday protection ­ The appliance switches itself off four hours after the last operator action. Cleaning and care Caution: Avoid sharp and caustic cleaning agents as well as brushes and abrasive cleaners. Clean the stainless steel tub with mild rinsing detergent and apply stainless steel care agent to the metal surfaces using a soft cloth. Do not use any cleaning agent as it might be agressive to the inscription markings. Grease filter cleaning The grease filter indication symbol lights up on the operating panel after around 30 hours of operation. Illumination of this symbol signals to you that the grease filters have to be cleaned. You can clean the metal grease filters in a dishwasher at a maximum temperature of 65 °C / 150 °F . To do this, place the grease filters in the dishwasher in such a way that it is cleaned completely. Proceed as follows: ­ Turn the "Height adjustment" control knob to the right to extend the boom slightly. ­ Turn the two retaining wires up and remove the grease filter from the appliance. Fig. 6 ­ Turn the control knob to the position (grease filter indication). Only clean the grease filter after the appliance has cooled down. 8 Swivel arm cleaning If the swivel arm gets very dirty, it can be dismantled for cleaning. You can clean the swivel arm in a dishwasher at a maximum temperature of 65 °C / 150 °F . [. . . ] After installation, plug the connecting cable plug in an accessible socket. If the plug can no longer be removed after installation, isolation of all poles from the mains must be ensured by means of an accessible isolator with a contact spacing of at least 3 mm. You can use the window switch if the appliance is only used when the window is open (to ensure adequate incoming air). This switch is connected to the window switch terminal on the main electronics. [. . . ]