User manual GAGGENAU VL430107 annexe 1

[. . . ] The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. Make sure that connecting cables do not come into contact with hot cooking surfaces. As the user, you are responsible for maintenance and proper use in the household. The appliance is intended solely for use in the household and must not be put to any other uses. [. . . ] Operation Note: VL 430 can only be operated in combination with VL 431. That is to say: if you press the key for level 1, both hob ventilators are operated at level 1. Switching on Press the corresponding membrane key for the required level. 1 = Low speed, the flaps open 2 = High speed = Approximately 10 minutes run-on time on level 1. Then, the hob ventilator switches off automatically and the flaps shut. Ideal for ventilating the kitchen after cooking. Switching off Press the 0 key. ­ If you have a combination of VL 430 and 431 and the flaps are open on one ventilator and closed on the other (for example an object is stuck in the flaps): Remove the object, press the 1 key. 6 4. Cleaning and care The grease filters must be cleaned on a regular basis (at the latest after 30 hours of operation). · Push the flaps towards the front and carefully lift them up on the rear. · Turn the two retaining hooks on the sides up and remove the metal grease filter. You can clean the metal grease filter in a dishwasher at a maximum temperature of 55 °C. Place the grease filter in the dishwasher with the opening pointing down to ensure that no food remainders will stay on it. Insert the flap pins on the front into the hole and hook in at the rear at the correct angle. Cleaning the frame and the membrane key pad Apply commercially available window cleaning agent with a soft, moist cloth. Assembly instructions Important notes on installation The appliance must only be connected by an authorised specialist. The specialist is responsible for perfect functioning of the appliance at its installation location. He must explain to the user how the appliance can be disconnected from the mains whenever required. The exhaust air can be routed into a separate exhaust air shaft or directly into the open through the outside wall. It is not allowed to pass the exhaust air into a flue or exhaust air chimney that is in operation or into a shaft that is linked to the heating basement. Consult the chimney sweep responsible for your district whenever you wish to pass the exhaust air into a chimney that is not in operation. Adequate incoming air must be ensured if a wood, coal, gas or oil heater or an open hearth is operated in the same room as the one in which the ventilator is installed. The applicable regulations of the power supply companies and the regional construction regulations must be observed when installing the hob ventilator. Safe operation is possible whenever the partial vacuum in the place where the firing equipment is installed does not exceed 4 Pa (0. 04 mbar). [. . . ] · Connect the appliance to the fan module by means of the 4-pole plug. We recommend the use of our telescopic wall box TM 180-043 to route exhaust air through the outside wall. Installing the edge trim AL 400-000 The edge trim has to be fitted to the side of the hob ventilator, if this ventilator is installed together with other Vario appliances and forms the left or right edge of this combination. The edge trim does not change the total width of the cut-out, however, the width of the edge trim has to be added to the total width of the appliance combination. [. . . ]