User manual GAGGENAU VR230934

[. . . ] 9000576482 901221 VR 230 934 ã Ú Installation instructions PLQ PLQ ¡ [ ¡ PLQ PLQ PLQ ko ã ã= ! . . en Ú Installation instructions Fitting the appliance 1. Fit the mounting rails to the Important notes Read these instructions carefully and keep them in a safe place. [. . . ] The snap-in pins on the appliance must lie exactly on the catch springs. Take the lava stones out of the plastic bag and pour them into the lava stone trough. Place the appliance cover upright onto the pre-fitted securing brackets. If necessary, align the appliance cover after loosening the screws on the securing brackets. Tighten the screws. The surrounding kitchen unit must be heat-resistant to at least 90 °C. The stability of the unit must be maintained after producing the cut-out. Observe a minimum clearance between the appliance housing and parts of the unit of 10 mm. Protection against accidental contact from below must be guaranteed after installation. If the underside of the appliance can be touched after installation, an intermediate shelf must be fitted that can only be removed using a tool. Observe a minimum clearance between the appliance and the shelf of 10 mm. When fitting several Vario appliances: allow for the additional space required for the connecting strip VV 200. Appliances can also be fitted in individual recesses, if a minimum clearance of 40 mm between the appliances is observed. Special instructions for installation outdoors Do not use charcoal or similar combustible fuels with this appliance. Operate the appliance on a residual current device (RCD) with a maximum tripping current of 30 mA. Attach a suitable plug for outdoor use to the mains cable (observe the respective national regulations). [. . . ] Only a qualified electrician who takes the appropriate regulations into account may connect a socket. The appliance corresponds to type Y: the mains connection cable must only be replaced by the after-sales service. Check the cable type and minimum cross section. Disconnect the appliance from the power supply. [. . . ]