User manual GORENJE TH62E4BG

[. . . ] Note: the elements marked with the symbol "(*)" are optional accessories supplied only with some models or elements to purchase, not supplied. Do not connect the appliance to the mains until the installation is fully complete. Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply. Always wear work gloves for all installation and maintenance operations. [. . . ] The hood is designed to be used either for exhausting or filter version. In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. Diameter of the exhausting pipe must be equal to that of the connection ring. In the horizontal runs the exhausting pipe must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. If the hood is supplied with active charcoal filter, then it must be removed. Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection flange). Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise. Use a duct with as few elbows as possible (maximum elbow angle: 90°). fILTER VERSION One active charcoal filter is needed for this and can be obtained from your usual retailer. The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet grid. iNSTALLATION The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. eLECTRICAL CONNECTION The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions. Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. The hood is provided with a special power cable ; if the cable is damaged, request a new one from Technical Service. mOUNTING Very heavy product; hood handling and installation must be carried out by at least two persons. before beginning installation: · Check that the product purchased is of a suitable size for the chosen installation area. This/these is/are to be mounted only if you Want to use the hood in the filtering version. Check (for transport reasons) that there is no other supplied material inside the hood (e. If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access to rear wall/ceiling. [. . . ] Trykk på knappen for hastighet 1 for å starte viftemotoren med hastighet 1. Trykk på knappen for hastighet 2 for å starte viftemotoren med hastighet 2. Trykk på knappen for hastighet 3 for å starte viftemotoren med hastighet 3. Sistemul de conducte pentru acest aparat nu trebuie conectat la niciun sistem existent de ventilaie care este folosit în alte scopuri precum evacuarea vaporilor de la aparatele care folosesc gaz sau alt combustibil. [. . . ]