User manual HAMA 12306 4 EN 1

[. . . ] Note: Code saver► ► Any codes you have programmed remain stored for up to 10 minutes while you replace the battery. Make sure you do not press any buttons before you have placed new batteries inside the remote control. All the codes will be erased if a button is pressed while there are no batteries in the remote control. note► ► This symbol is used to indicate additional information or important notes. [. . . ] A successful selection is indicated by the LED with one flash followed by permanent light. 4 Press the “POWER” or the PROG+/PROG- key to zap through the preloaded codes until the device you want to control reacts. Note: Scan Speed Settings► ► Scan Speed Settings can be set at either 1 or 3 seconds. To switch between the scan times, press PROG+ or PROG- during the 6 sec. 5 The LED indicator confirms each single code scan with a single flash. 7 To stop the Auto Code Search during the scan process, press the EXIT key. Note► ► Internal memory limitations allow only up to 350 most common device codes to be preloaded. Due to the extensive number of different available A/V devices on the market, it may be possible that only the most common main functions are available. 3 Auto Code Search Auto Code Search uses the same preloaded codes as the Manual Code Search (5. 2) but your Universal Remote Control scanns through the codes automatically until the device you want to control shows a reaction. This might be that the device you want to control switches off (POWER key) or changes the channel (P+/P- keys). A successful selection is indicated by the LED with one flash followed by permanent light. The Universal Remote Control has a latency of 6 seconds before the first scan starts. 4 Note► ► When all codes are searched without success, the Universal Remoote Control exits Auto Code Search and returns to operational mode automatically. 4 Code Identification The Code identification offers you the possibility, to determine an already entered code. A successful selection is indicated by the LED with one flash followed by permanent light. The LED indicator flashes once to indicate the first digit of the 4-digit code number. CODES TV VCR SAT DVD AUX AMP CBL DVBT To deactivate the punch through volume setting:• • Press desired device mode key (e. €¢ • Release “VOL-” (the indicator is flashing twice if the setting is deactivated). 3 Macro Power Macro Power enables you to turn two A/V devices on/off simultaneously. To activate the macro power setting:• • Press desired device mode key (e. €¢ • Release “POWER” (the indicator flashes once if the setting is activated). [. . . ] Service and Support If you have questions on the product, you are welcome to contact Hama Product Consulting. Recycling Information Note on environmental protection: After the implementation of the European Directive 2012/19/EU and 2006/66/EU in the national legal system, the following applies: Electric and electronic devices as well as batteries must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. [. . . ]