User manual HOLMES HACP9TG

[. . . ] 10) Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by The Holmes Group may cause hazards. 14) WARNING: To reduce the risk of fire or electric shock, DO NOT use this fan with any solid-state speed control device. [. . . ] Do not allow the motor or other electrical components to be exposed to water. WALL MOUNTING INSTRUCTIONS NOTE: On the underside of the fan's clip there are "KEY SLOTS" (2). Select a suitable spot on a wall (away from curtains, draperies, or heat sources) where you want to mount the fan. 10 pan head wood screw (1 1/4" length) and thread into a 2x4 wood stud behind the dry wall. Please refer to the warning below if you are unable to locate a wood stud in the wall. When threading the screw into the wall, leave approximately 1/4" clearance between the screw and wall. This will allow the clip's "KEY SLOTS" to fit easily and securely over the screws. If necessary, the screw may be tightened further to ensure the fan is firmly attached to the wall. WARNING: WHEN MOUNTING THE FAN TO PLASTER, DRYWALL OR SHEETROCK, YOU MUST USE A MOLLY BOLT, OR SIMILAR FASTENER. DOING SO WILL PREVENT THE FAN FROM BECOMING DISLODGED WHILE IN OPERATION. FAN STORAGE In the off-season: · IMPORTANT: Keep your fan in a safe dry location, where the fan is not likely to fall or be crushed. · Your fan should be stored fully assembled. · Remember to protect the fan head from dust or moisture. ADJUSTMENT INSTRUCTIONS Vertical Angle Adjustment Step 1: Step 2: To change the tilting angle of the fan head, simply loosen the tilt adjustment knob. Move the fan head to the desired angle, then firmly tighten the knob to lock the fan head in place. Horizontal Angle Adjustment Turn the motor housing to the desired direction. WARNING: MAKE SURE TO SUPPORT THE FAN HEAD ASSEMBLY WHEN LOOSENING THE ADJUSTABLE HEIGHT NUT, AS THE WEIGHT OF THE FAN HEAD MAY CAUSE THE EXTENSION POLE TO COLLAPSE. SERVICE INSTRUCTIONS 1. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. If you have any questions regarding this unit's operation or believe any repair is necessary, please write to our Consumer Service Department. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store you purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed warranty. If you have any other questions or comments, see our correspondence below: Please visit our website: www. holmesproducts. com Or write to: The Holmes Group, Inc. Box 769 Milford, MA 01757-0769 For your own records, staple or attach your sales receipt to this manual. [. . . ] IMPORTANT Return INSTRUCTIONS Your warranty depends on your following these instructions if you are returning the unit more than 30 days after the date of purchase: 1. Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) your name, full address with zip code and telephone number, b) a dated sales receipt or PROOF OF PURCHASE, c) your $5. 00 check for return packaging, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. [. . . ]