User manual HUAWEI ECHOLIFE HG510 HOME GATEWAY

[. . . ] EchoLife HG510 Home Gateway User Manual HUAWEI TECHNOLOGIES CO. , LTD. Free Communication, Wonderful Life Thank you for choosing EchoLife HG510 Home Gateway of Huawei Technologies Co. , Ltd. EchoLife HG510 Home Gateway User Manual Issue Product Version Date No. 02 V100R001C05 2006-10-14 202012 Copyright © Huawei Technologies Co. , Ltd. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co. , Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co. , Ltd. All other trademarks and trade names mentioned in this document are the property of their respective holders. Notice The information in this document is subject to change without notice. Every effort has been made in the preparation of this document to ensure accuracy of the contents, but all statements, information, and recommendations in this document do not constitute the warranty of any kind, express or implied. Caution The HG510 is used indoors only. [. . . ] Quick setup allows system administrator to select the appropriate operation mode and set the corresponding parameters to establish connection with the network. Table 4-1 describes the ADSL service modes and the related protocol types. Huawei Technologies Proprietary 4-14 User Manual EchoLife HG510 Home Gateway Chapter 4 Configuration Table 4-1 ADSL service modes Protocol Type Preparation Virtual Dialup Pure bridge WAN connecti on Dedicated Line RFC 2684 routing (IPoA) WAN connecti on PPPoE PPPoA MER WAN connection PPPoE user name and password VPI/VCI None None None WAN connection PPPoA user name and password VPI/VCI None None None WAN connectio n VPI/VCI VPI/VCI VPI/VCI None None None None WAN IP Subnet mask Default gateway DNS WAN IP Subnet mask Default gateway DNS The following sections describe the configuration of these five service modes in details. 4. 2. 1 Configuring PPPoE Click Quick Setup in the left frame, and follow the steps below to create a PPPoE connection. Follow the steps listed below to configure PPPoE. Huawei Technologies Proprietary 4-15 User Manual EchoLife HG510 Home Gateway Chapter 4 Configuration Step 1 2 3 4 5 6 Action Configure ATM PVC. Configure ATM PVC Figure 4-19 Quick Setup ­ ATM PVC Configuration 1) 2) Enter the VPI/VCI values. Click Next to go to the next step. Huawei Technologies Proprietary 4-16 User Manual EchoLife HG510 Home Gateway Chapter 4 Configuration II. Select Connection Type and Encapsulation Mode Figure 4-20 Select Connection Type and Encapsulation Mode 1) 2) 3) Select PPP over Ethernet (PPPoE) as the connection type. Configure PPP Username and Password Figure 4-21 Configure PPP Username and Password Huawei Technologies Proprietary 4-17 User Manual EchoLife HG510 Home Gateway Chapter 4 Configuration 1) 2) As shown in Figure 4-21, enter the username and password of the PPP service and the PPPoE service name. The Dial on demand (with idle timeout timer) function, if checked, a new setup parameter Inactivity Timeout (minutes) [1-4320] will be displayed. This parameter defines the wait time for HG510 to disconnect the PPP link automatically if there is no outgoing packet. The user is able to assign some specific ATM PVC(s) to run PPPoE, when HG510 has multiple ATM PVC connection. 3) Click Next to go to the next step. IV. Enable IGMP Multicast and WAN Service Figure 4-22 Enable IGMP Multicast and WAN service 1) 2) Select Enable IGMP Multicast, Enable WAN Service, Enable NAT or Enable Firewall as required. Click Next to go to the next step. Huawei Technologies Proprietary 4-18 User Manual EchoLife HG510 Home Gateway Chapter 4 Configuration V. Configure LAN Service Figure 4-23 Configure LAN Service 1) 2) 3) Enter the IP address (192. 168. 1. 1 by default) and the subnet mask (255. 255. 255. 0 by default). If you select Configure the second IP Address and Subnet Mask for LAN interface, configure the related settings. 4) Click Next to go to the next step. Note: The NAT function is enabled by default. It is not displayed on the configuration page, to prevent it from being disabled. Huawei Technologies Proprietary 4-19 User Manual EchoLife HG510 Home Gateway Chapter 4 Configuration VI. WAN Setup ­ Summary Figure 4-24 WAN Setup ­ Summary The last page gives a summary of previous steps. Then click Save/Reboot to complete the configuration procedure. 4. 2. 2 Configuring IPoA Click Quick Setup in the left frame, and follow the steps below to create an IPoA connection. Refer to Huawei Technologies Proprietary 4-20 User Manual EchoLife HG510 Home Gateway Chapter 4 Configuration Step 4 5 6 Action Enable NAT, IGMP Multicast, and WAN service. Configure ATM PVC Figure 4-25 Configure ATM PVC 1) 2) Enter the VPI/VCI values. Click Next to go to the next step. Huawei Technologies Proprietary 4-21 User Manual EchoLife HG510 Home Gateway Chapter 4 Configuration II. Select Connection Type Figure 4-26 Select Connection Type 1) 2) Select IP over ATM (IPoA). [. . . ] Summary WAN settings LAN statistics WAN statistics ATM statistics ADSL statistics Route information ARP settings DHCP settings Do. . . Select Device Info > Statistics > ADSL to display the ADSL page. Select Device Info > DHCP to display the Device Info-DHCP Leases page. 5. 2 Managing Device Settings System Administrator can back up, update and restore HG510 settings in this configuration page. The saved setting file can also be loaded from computer to HG510. Huawei Technologies Proprietary 5-2 User Manual EchoLife HG510 Home Gateway Chapter 5 Maintenance These functions can help the system administrator to manage large amount of HG510 efficiently. [. . . ]