User manual HUSQVARNA 400 COMPUTER

[. . . ] Com manuals search engine This houshold sewing machine is designed to comply with IEC/EN 60335-2-28 and UL1594 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic safety precautions should always be followed, including the following: Read all instructions before using this household sewing machine. DANGER - To reduce the risk of electric shock: • A sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electric outlet immediately after using and before cleaning. WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons: • Do not allow to be used as a toy. [. . . ] The arrows of the outer and the inner hoops should both be at the bottom. Slide the hoop under the presser foot – raise up the presser foot lever to take advantage of the extra lift of the presser foot. Note: Always sew a sample Embroidery on a scrap of the same fabric you will embroider. When embroidery is completed, raise the presser foot before removing the embroidery hoop from the machine. Press the purple button located to the right on the hoop and pull the hoop towards you. Com manuals search engine Note: Always touch CLR before you turn off the machine. Otherwise the embroidery arm will not come to the park position to remove the unit from the machine. 30 Embroidery Using the Embroidery template When you wish to sew the embroidery at a speci c place on your fabric or garment, you can take advantage of the embroidery template to mark where the embroidery is to be sewn. In the Embroidery Booklet you will nd all the embroideries pictured in actual size. Place the template with the arrow pointing downward and matching the other marks. Draw the outer lines of your selected embroidery on the template using the template pencil. Place the template on your fabric where you wish to sew the embroidery. Draw marks on the fabric in the four grooves and in the center with your Pictogram™ pen. Place the embroidery hoop matching the arrow pointing downward to the arrow mark on the fabric. Insert the fabric into the hoop, see ”Embroidery hoop”, page 30. Make nal adjustments using the until the positioning buttons needle will start at the center. Thread the bobbin thread according to "Threading" on page 12 and check to be sure the thread lies under the tension springs. Always check there is enough bobbin thread before starting a new embroidery. The symbol ashing on the Infodisplay indicates if the embroidery card is not inserted or not inserted fully. The machine always starts from the center of the embroidery area, sews a starting stitch up to the beginning of the embroidery, sews a few stitches more, gives a ”beep” and stops. A pair of scissors ashing on the display indicates that you can cut the starting thread tail. Touch the button and the machine sews the rest of the embroidery or up to next thread color change. [. . . ] The stitch is too loose - fabric layers not held together The thread tension is far too loose. 60 Care of your Scandinavia 400 Incorrect stitch If the machine does not sew the stitch indicated by the Infodisplay, it is possible that the electronics have been disturbed in some way, perhaps by a short power cut or electrical disturbance. Machine runs sluggishly The sewing and embroidery machine screen does not respond to touch Dirt or lint has built up under the stitch plate. Loosen the plate and brush clean between the feed teeth and in the bottom area. [. . . ]