User manual INDESIT IWDD7143S

[. . . ] Remove the 4 protective screws and the rubber bush with the respective spacer, situated on the rear of the appliance (see also the installation leaflet). 1. Connect the supply pipe by screwing it to a cold water tab using a 3/4 gas threaded connection (see figure). Before performing the connection, allow the water to run freely until it is perfectly clear. Connect the other end of the water inlet hose to the washer-dryer, screwing it onto the appliance's cold water inlet, situated on the top right-hand side on the rear of the appliance (see figure). [. . . ] B - Based on the damp level of the dry clothes: : slightly damp clothes, easy to iron. Hanger : very dry clothes, recommended for towelling Cupboard and bathrobes. A cooling stage is foreseen at the end of the drying cycle. Setting the temperature GB The data contained in the table are purely indicative. Set the drying cycle Table of drying times Fabric type Load type Max. load (kg) Cupboard Hanger Iron Cotton, Linen Cotton Terital, Cotton Acrylics Clothing of different sizes 5 5 2, 5 1 180 180 140 70 170 170 120 65 140 140 100 60 Terry towels Sheets, Shirts Pyjamas, socks, etc. Slips, tights, stockings, etc. If your laundry load to wash and dry is exceptionally in excess Nylon 1 70 65 60 of the maximum load foreseen (see table opposite), perform the wash cycle, and when the programme is complete, divide up the garments and put part of them back in the drum. Repeat this procedure for the remainder of the load. Dry only Turn the PROGRAMME knob to one of the drying settings (7-8) depending on the type of fabric, then select the desired drying type using the DRYING knob. Important: - A spin cycle is carried out during the drying if you have set a cotton programme and a level of , Hanger , Iron ). dryness (Cupboard - For cotton loads of less than 1 Kg, use the drying programme designed for delicate fabrics. Functions To enable a function: 1. press the button corresponding to the desired function, according to the table below; 2. Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set. Function Effect Delays the start of the wash by up to 9 hours. Comments Press the button repeatedly until the LED corresponding to the desired delay is turned on. • Never touch the washing machine when barefoot or with wet or damp hands or feet. • Do not pull on the power supply cable to unplug the appliance from the electricity socket. • Do not open the detergent dispenser while the appliance is in operation. • Do not touch the drain water as it could reach very high temperatures. • Never force the washing machine door: this could damage the safety lock mechanism designed to prevent any accidental openings. • In the event of a malfunction, do not under any circumstances touch internal parts in order to attempt repairs. • Always keep children well away from the appliance while in operation. • Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. • Before loading your laundry into the washing machine, make sure the drum is empty. • Do not use the appliance to dry clothes that have been washed with flammable solvents (e. g. trichlorethylene). Disposal • Disposing of the packaging material:observe local regulations, so the packaging can be re-used. [. . . ] • To comply with new energy saving regulations the machine is fitted with an automatic standby system. Press 'ON/OFF' button for 3 seconds to activate the machine, it can then either be switched off or a new programme selected. • Your washing machine contains sensors that monitor progress during the wash cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/progress). Normally, if your machine successfully completes the cycle, there is unlikely to be anything wrong! Remember, you will be charged for a service call for problems caused by incorrect installation, as listed above. [. . . ]