User manual IOGEAR GIC711SW6

[. . . ] Installation Guide eSATA 1. 5Gbps 1 external + 1 internal port Low profile PCI card GIC711SW6 1 PART NO. M0559 Table of Contents Introduction Features Package Contents Software Installation Federal Communications Commission (FCC) Statement CE Statement Limited Warranty Contact 4 5 6 7 11 13 14 15 3 Introduction The Low Profile Serial ATA 2 Channel PCI Host Adapter can support both Low profile PCI and standard size PCI. [. . . ] When the Found New Hardware Wizard starts, check the option to Install from a list or specific location (advanced), and click Next. 8 2. Point the wizard to the following location: [CD Drive Letter]:\SATA Non-Raid_2Port\ Sil3x12\ Win98_me _2000_xp_nt4. 0 \ Driver, click OK then Next. Once the drivers have been installed click Finish to finalize the installation. 9 Verification of Proper Installation for Windows XP 1. Double click SCSI and RAID Controllers, then double click Silicon Image Sil-3x12 SATALink Controller to display the driver properties. If the message This device is working properly is displayed in the dialog box, then the driver has been correctly installed. 10 Federal Communications Commission (FCC) Statement Federal Communications Commission (FCC) Statement 15. 21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user's authority to operate the equipment. 15. 105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. 11 - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. this device must accept any interference, including interference that may cause undesired operation of the device. FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. [. . . ] GREEN IOGEAR is an environmentally conscious company that emphasizes the importance of conserving natural resources. By integrating products with the latest scientific developments, IOGEAR's solutions enhance the life of end-users. © 2007 IOGEAR, INC. [. . . ]