User manual IOMEGA 2CLIKTRO

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual IOMEGA 2CLIKTRO. We hope that this IOMEGA 2CLIKTRO user guide will be useful to you.


IOMEGA 2CLIKTRO : Download the complete user guide (214 Ko)

Manual abstract: user guide IOMEGA 2CLIKTRO

Detailed instructions for use are in the User's Guide.

[. . . ] (See the Clik!TM Drive User's Manual for technical support policies. ) a. The Clik!installation program freezes during the installation process. The Clik!Desktop Dock for the installation program to run properly. TM The Clik!Mobile Drive and a Zip® drive together via their passthrough ports. [. . . ] (See also "Daisy Chaining Parallel Port Devices" on page 9 of the Clik!TMDrive User's Manual. ) 3. Mobile Drive and your printer share the parallel port and cannot be used at the same time. If your system locks up when Windows® is loading, reboot using Safe Mode and follow the instructions below to remove the Clik!Windows® should then state that it found the "Standard IDE/ESDI Hard Disk Controller. " Click Finish to allow Windows to install the listed driver. Mobile Drive will not function properly if you cancel this procedure without finishing. If a prompt is received to have Windows® search for a driver, follow the steps above. Expand the Hard Disk Controllers section, and remove the PCMCIA adapter. This adapter may also be labeled as PCMCIA ATA Controller or something similar. Parallel Port Interface" is present with a yellow exclamation point on top of the SCSI icon, highlight it and click Remove. PC Card Adapter removal instructions on page 27 of the Clik!TM Drive User's Manual. d. Reboot the system and let Windows® search for the updated driver as outlined above. Select Devices by Type, make sure the Computer icon is highlighted, and click on the Properties button. Review the "Printer Troubleshooting for Windows® 95/98" section on page 45 of the Clik!TM Drive User's Manual. If you have a printer connected to the parallel port of your notebook, and cannot print, remove the Clik!(Follow the previously givien instructions under "My System locks up . Make sure Interrupt Request (IRQ) is selected and review the list of 00-15 IRQ assignments. If all the IRQs are used, you will need to free an interrupt in order to use the Clik!Hint: Select a device, such as a COM port, that is not currently in use and disable that device. (See Windows Help--Freeing Resource Setting Used by disabled hardware. ) After freeing an IRQ, restart your computer system and insert the Clik!PC Card Adapter. I'm having trouble getting the Clik!TM Flash Card Reader to read my SmartMediaTM cards. 1. [. . . ] If the error "Failed to load image file" occurs while using PhotoPrinter, you may need to change your parallel port mode in the BIOS from EPP to ECP. (See your computer's documentation for information on changing the BIOS setting. ) 4. If some of the thumbnails show up as red X's, you may need to change your parallel port mode in the BIOS from EPP to ECP. (See your computer's documentation for information on changing the BIOS settings. ) The Clik!TM software installation reassigned my CDROM drive letter. Windows® 95/98 Users: follow the directions found in Windows Help to reassign drive letters. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE IOMEGA 2CLIKTRO




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual IOMEGA 2CLIKTRO will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.