User manual JATA CA1051

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JATA CA1051. We hope that this JATA CA1051 user guide will be useful to you.


JATA CA1051 : Download the complete user guide (617 Ko)

Manual abstract: user guide JATA CA1051

Detailed instructions for use are in the User's Guide.

[. . . ] €¢â€‚ Do not connect the coffee maker to the mains without checking that the voltage on the rating plate and that of your household are the same. €¢â€‚ Make sure the plug has an adequate earth base. €¢â€‚ Don’t allow children play with the appliance. €¢â€‚ Keep the appliance and the cable cord out of the reach of children less than 8 years old. [. . . ] €¢ Plug the coffee maker to the mains and push the on button (7). €¢ When connecting the coffee maker for the first time, it must be pre-heated. To do it, press the buttons 1 and 2 cups (8 and 9) at the same time during 3 seconds. The coffee maker will start to heat and the indicator light (4) will flash till reaching the correct temperature to make coffee, keeping the light fixed. €¢ Before making any operation, always be sure that the steam regulator (5) is in off position “-”. €¢ Chose the filter (11 or 12), place it in the filter holder (10) and fill it depending on the coffee quantity you need: -- 1 cup of coffee: fill the filter for 1 cup (11) with the spoon filled of ground coffee (7 g). -- 2 cups of coffee: fill the filter for 2 cups (12) with the spoon filled twice of ground coffee (14 g). €¢ Press the coffee with the back side of the spoon, being sure there is not coffee remains in the edge of the filter holder. €¢ Insert the filter holder (10) in its place by aligning the handle with the indication , pushing up and turning to the right, to the indication until it is correctly inserted. Make sure that the handle of the filter holder stays in perpendicular position when closing (90º). €¢ Place the cup or the cups in the tray (14) under the filter holder and switch on the coffee maker into the mains. €¢ Press the button for 1 cup (8) to get a cup of coffee with (50 ml) or 2 cups button if you need 2 coffee cups with (100 ml). It will switch on the pilot light (2) and the coffee will start to flow. €¢ Once finished, press the off button (7) and unplug the appliance. START COFFEE ADJUST THE COFFEE VOLUME • Press the button for 1 cup or 2 cups (8 and 9) during 3 seconds. €¢ The coffee maker will memorize that coffee quantity and once pressed the buttons for 1 cup or 2 cups (8 or 9) you will get that programmed quantity of coffee. €¢ To adjust again the original quantity, press the buttons 1 and 2 at the same time during 3 seconds. The pilot light (4) will flash and the adjustable volume will change once the pilot light stops flashing. WARMING CUPS • Place the cups upside down in the warming plate (3). Indd 11 26/03/19 16:17 The coffee maker will switch off automatically after around 15 minutes from its operation, to comply with Directive 2009/125/EC of the European Parliament. [. . . ] It is convenient to treat them as follows: -- Pour a 50% white vinegar solution into the tank and wait for 15 minutes. -- Plug in the coffee maker without coffee in the filter and allow all the solution to flow out. -- Next, make the coffee maker work only with water a couple of times. €¢ Cleaning the steamer: in case of obstruction use the included needle (16) to clean the steam hole. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JATA CA1051




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JATA CA1051 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.