User manual JBSYSTEMS CLUB LASER 7 MK2 V 2.0

[. . . ] `t Hofveld 2 ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. [. . . ] The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that BRITEQ cannot be made liable for damages caused by incorrect installations and unskilled operation!HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging") 7. Use the keys to make sure only a skilled operator is able to switch the laser on. INTERLOCK input: used to connect the optional emergency stop switch (see picture). For your own safety we strongly recommend to connect this optional switch!Apart from DMX-mode you can also select 4 other working modes, see further to learn more about these modes. CONTROL PANEL: Used to control the different functions of the laser, see further to learn how to operate the unit. DMX OUTPUT: 3pin female XLR-connector used to connect the laser with the next unit in the DMX chain. INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. X/Y SIZE CONTROL: use these controls to adapt the size of the projected graphics to the dimensions of the venue. This is for example useful when you project graphics from behind a transparent screen. X/Y mirror can also be set with the control panel and LED display, see chapter "HOW TO SET UP" to learn how this works. ILDA INPUT: used to connect the laser to an ILDA certified interface of a computer, see further for more information. COOLING FAN (input): used to cool the components inside the enclosure. Make sure that the filter inside the fan is always in place before you turn the laser on!Just tear off the plastic cover and clean the filter with a vacuum cleaner. COOLING FAN (output): used to cool the components inside the enclosure. LASER OUTPUT: Here the laser beam leaves the enclosure, make sure to NEVER look inside the unit through this opening while the laser effect is switched on!LASER WARNING SIGN: warns against a potentially dangerous laser when not used by skilled operators. [. . . ] (display blinks "888" 3times) The Club laser7 Mk2 laser uses 17 channels, please refer to the DMX-chart below for the functions of the different channels. Some more information on DMX512: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected light effects with a good quality XLR M/F balanced cable. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. [. . . ]