User manual JENSEN CR560X
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JENSEN CR560X. We hope that this JENSEN CR560X user guide will be useful to you.
Manual abstract: user guide JENSEN CR560X
Detailed instructions for use are in the User's Guide.
[. . . ] 5 · Cars with a Single Speaker Wire . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Wiring DiagramAdvanced Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Technical Assistance
For technical assistance with the installation of the CR560X, call 1-800-323-0221.
5588 CR560X_EIN. p65
1
2/29/00, 10:46 PM
®
CR560X
Installation
Before You Begin Installation
Before you begin, you will need tools, supplies and adapters. It is best to make sure you have everything you need before you take your dashboard apart.
Tools and Supplies Needed
Basic Installation:
· · · · Flat and Phillips screwdrivers Wire cutter Wire stripper Tools to remove existing radio (screwdriver, socket wrench set or other tools) · Radio removal tool · Electrical tape
Adapters for Easier Installation
Electrical and dashboard adapters make installation easier. [. . . ] Use a rag or wear a glove.
1
COMPACT
EJECT
DIGITAL AUDIO
RGCD 400
CD
8 X OVERS AMPLIN G. .
. 4X
15 WATTS
PWR BASS MO/ST DISP LO/DX INT RPT RDM BAND CD VOL SEL VOL
4
5588 CR560X_EIN. p65
4
2/29/00, 10:46 PM
®
CR560X
Install Half-sleeve
Not needed for ISO-DIN (Japanese vehicle) installation.
3
Support Strap (supplied)
Half-sleeve (supplied)
1
Adapter (optional)
2
1. Bend over tabs where possible to secure half-sleeve to adapter or inside of dash. Secure strap to an existing screw.
Wiring
Important If wiring connections are made wrong, the unit will not operate properly and it could be damaged. Follow the installation instructions carefully, or have the installation handled by an experienced technician.
Professional Tip
Fuse Adapters
No convenient power wire?Install a fuse adapter having a spade connector.
Fuse
Fuse Adaptor
Crimp on a matching connector and attach: · Yellow wireFuse marked MAIN, BAT or PWR · Red wireFuse marked ACCY (accessory), or RADIO
5
5588 CR560X_EIN. p65
5
2/29/00, 10:46 PM
®
CR560X
Wiring with a Wiring Adapter
This is the easiest wiring method, because it replaces your existing radio. You will have to buy a wire harness adapter from your dealer, a car stereo installation shop or electronics store. If you use a wiring adapter, you can connect all wires to the radio before you even start to take your old radio out.
Connect Wires
Splice, crimp or solder the wires from the Jensen connector to the wiring adapter. Match the wires according to the chart (below) and the wiring adapter instructions.
Splices You can make all these connections without even being in the car.
Install Wiring Inside the Car
1. Slide radio part way into half-sleeve.
1 Car Wiring Harness
3
Antenna Extender Cable
2
Car Antenna Lead
Wiring Adapter (attach to car wiring harness)
Wiring Color Codes
Function LF Speaker LF+ Speaker LR Speaker LR+ Speaker RF Speaker RF+ Speaker RR Speaker RR+ Speaker Power Antenna Ground Ignition Battery Color white/black white green/black green gray/black gray violet/black violet dark blue black red yellow
Go to Testing on page 8.
6
5588 CR560X_EIN. p65
6
2/29/00, 10:46 PM
®
CR560X
Wiring DiagramAdvanced Installation
If you are installing new speakers or amplifiers or replacing an aftermarket installation, use this diagram.
Back of Radio Antenna Jack
RCA-to-RCA cables Amplifier wiring (not supplied) (See amplifier instructions) Red AMP White
Dark Blue
Power Antenna Connect to power antenna or amplifier. If not used, tape bare end of wire.
AMP
Turn on for amps Filter Box
Black
Ground Connect to ground terminal or clean, unpainted metal part of chassis.
+
In-line Fuse (5 amp)
Yellow
Memory Connect to battery or 12 volt power source that is always live. The radio will not store time or station presets if this wire is not connected.
Accessory Connect to existing radio wire or radio fuse. The radio will not work if this wire is not connected.
In-line Fuse (. 5 amp)
Red
LF
LF-- white/black white LF+ LR-- green/black green LR+
RF-- gray/black gray RF+ RR-- violet/black violet RR+
RF
Fuses
When replacing a fuse, make sure new fuse is correct type and amperage. The CR560X uses two fuses with in-line fuse holders as part of rear wiring harness: · 5 amp fast blow AGC (yellow wire). Go to Testing on page 8.
LR
RR
7
5588 CR560X_EIN. p65
7
2/29/00, 10:46 PM
®
CR560X
Testing
Before you finish the installation, you should do the following tests to make sure the wiring is correct and everything is operating properly.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Test Memory Wiring
1
1
--
+
2
Test Power Wiring
1. If not, make sure the yellow wire is connected properly.
Set the Clock
Press DISP button to display the clock.
1
DISP
Test Antenna Connection
1
1. Mount factory brackets on new radio using existing screws from old radio. Install faceplate by fitting left edge into position then pushing right edge closed.
3 1 4 5 2
AS/P S BAN D VOL+ CD SEL MUT E LOUD
VOLSCAN
MON O DISP
1 2 3 4 5 6
STER
EO
FM
1 CH BAS
®
REL
CR56
0X
10
5588 CR560X_EIN. p65
10
2/29/00, 10:46 PM
®
CR560X
Troubleshooting
Problem
Does not operate (radio does not light)
Cause
No power to red wire (12V with key on) Inline fuse blown
Corrective Action
Check connection Check vehicle fuse Replace fuse Connect speaker wires Check all splices and connections Check splices, insulate all bare wires Insulate wire Insulate wire Install fuse of correct rating Call Jensen Technical Assistance (1-800-323-0221)
No speakers operate (radio lights normally) Not all speakers operate
Speaker wires not connected Incorrect splices or connections Speaker wires shorting to chassis ground or to each other
Blows fuses
Power wire shorting to ground Speaker wires shorting to ground Incorrect fuse
Can't find cause of problem
Removing Radio from Dash
Professional Tip
Securing Wires
Be proud of your installation!(But never bundle speaker wires and power wires together!)
PWR AMS BAN D VOL CD
+
MUT E
LOU D
SEL
VOL
-
MON O DISP
1 2 3 4 5 6
SCA N
STER
EO
FM
1 CH BAS
®
REL
CR560X
Removal Key
Secure loose wires to the car to make sure they don't rub or rattle.
1. Remove trim ring by gently pulling up on the middle of the trimming to release the plastic snaps. Insert removal keys between radio and dash trim to depress locking springs. Pull radio out of dash.
11
5588 CR560X_EIN. p65
11
2/29/00, 10:46 PM
Specifications
FM Tuner Tuning range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87. 5 MHz-107. 9 MHz FM mono sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] We will either inform you of the name and address of an authorized Jensen repair station which will service the product or will advise you to send the product to a factory service center. The product should be returned to the Jensen dealer from whom it was purchased and such dealer either will service or arrange for service of the product. The original dated bill of sale must always be included with the product as proof of warranty coverage. We will pay for all labor and material expenses required to repair the product, but you must pay any labor costs for the removal and/or installation of the product. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JENSEN CR560X
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JENSEN CR560X will begin.