User manual JENSEN JCR-150

[. . . ] Clean only with a dry cloth. E-1 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) 17) 18) 19) Do not block any ventilation openings. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] The Alarm Two indicator on the display (#26) will light once complete. E-12 TO SET THE ALARM WAKE SOUNDS (AL1/AL2) 1. Start by saying the trigger word "Smart Talk" or press the SNOOZE BAR (#11). The unit will reply "Yes" and will wait for your next command. Say "Alarm Sound" and the unit will reply "To set alarm sound, please say Alarm One or Alarm Two". You can also say the command "Cancel" during this step if you wish to cancel setting the alarm sound. If the unit fails to understand the alarm source given, it will reply, "Please Repeat". If the unit fails to understand the alarm source given a second time, it will reply "I'm sorry. I did not understand you, please start over or set the alarm sound manually". If this occurs, repeat steps #1 - 4 above again making sure you speak clearly in a normal voice. When the alarm source is successfully understood, the unit will reply, "To choose an alarm sound, say Ocean, Rain, Brook, Radio or Beep". You can also say the command "Cancel" during this step if you wish to cancel setting the alarm sound and the unit will reply "OK" to confirm. The snooze function can be repeated for a maximum of 6 times within 60 minutes from the original preset alarm time. When any alarm is sounding, press the SNOOZE BAR (#11) for a 9-minute snooze. You can repeat snooze operation for a maximum of 6 times within 60 minutes from the original preset alarm time. The alarm will now be off and ready to sound the next day at the preset time. When the designated alarm time is reached, there will be a periodic pause in the alarm sound if you have chosen a nature sound (Ocean, Rain or Brook) or the Beep for your wake alarm. This is normal and during the pause is where the unit is listening for the "Snooze" command. Note: If radio is chosen as the alarm sound, it will play without interruption and therefore you will not be able to use Smart Talk "Snooze" command to activate the snooze. This will need to be done manually by pressing the SNOOZE BAR (#11). E-15 2. Say "Snooze" during one of the pauses in the alarm sound to activate the 9-minute snooze. If your command is correctly recognized, the SNOOZE INDICATOR (#28) will turn on. You can repeat snooze operation for a maximum of 6 times within 60 minutes from the original preset alarm time. [. . . ] Solution - Change to a quieter place or speak closer to the unit's mic at louder voice. - Voice recognition is not designed to work in radio mode, you need to use manual settings instead. - Set the Trigger Switch (#3) to the OFF position to temporarily disables the Smart Talk feature. - Say "Cancel" if you hear the unit saying "Yes" on its own. [. . . ]