User manual JENSEN JIMS-185 DATASHEET

[. . . ] Over time your hearing "comfort level" adapts to higher volumes of sound. So what sounds "normal" can actually be loud and harmful to your hearing. Guard against this by setting your equipment at a safe level BEFORE your hearing adapts. To establish a safe level: · Start your volume control at a low setting. [. . . ] To avoid re-program the time and alarm settings, we recommend leaving the unit plugged in when changing the batteries. 9 SETTING THE CLOCK In case the back-up batteries are accidentally removed. In standby mode, press the UP button to increase or press the DOWN button to decrease the minutes setting. Press and hold the UP / DOWN button to fast forward/backward the clock setting. In standby mode, press and hold MEMORY/SET button for 3 seconds, Time flashes on LED display when the time is AM, "PM" and time flashes on LED when time is PM. Press the UP button to increase or press the DOWN button to decrease the minutes setting. Press and hold the UP / DOWN button to fast forward/backward the clock setting. NOTE There is a PM indicators located in the right-hand corner of the clock display. Be sure to observe the correct AM / PM time when setting the alarm to make sure the wake time is set correctly for AM or PM. RADIO OPERATIONS LISTENING TO RADIO 1. To manually tune the radio station, press the TUNE + or TUNE - button repeatedly. To automatically scan to the next radio station with the strongest signal, press and hold the TUNE + or TUNE - button for 1-2 seconds until frequency readout on the display begins to scan and then release the button. The tuner will stop scanning when it receives the next strongest station signal. Please note that excessively high volume may still block outside sounds. ALARM OPERATIONS SETTING THE WAKE UP TIME This unit has Dual Alarm function. In standby mode, press and hold ALARM1 or ALARM2 button for 3 seconds to enter the ALARM setting mode, LED shows the default alarm time 12:00 AM and the ALARM1 or ALARM2 indicator flashing on the display. Press and hold the button for fast forward / backward setting the alarm time. Press ALARM1 or ALARM2 button again to confirm the ALARM time setting. Press ALARM1 or ALARM2 repeatedly to select wake to ALARM (buZ) , RADIO (rAd), iPod / iPhone (IPod) or turn off the alarm. CHECKING THE WAKE UP TIMES To check the wake up time, simply press and hold the ALARM 1 or ALARM 2 button for 3 seconds. Release the ALARM button, it will return to current time after 5 seconds. To select wake to radio mode, press the ALARM button you want to set repeatedly until the display shows "rAd". Release the ALARM button and waiting about 3 seconds to confirm. 13 NOTE: The last radio station you listen to will be the same station you will wake to. The radio will automatically turn on and the ALARM indicator will flash when the alarm time is reached. The radio alarm will keep sounding for 60 minutes and then automatically shut off and resets for wake up at the same time the following day. [. . . ] If you connected the Headphone Jack of your external device then you may need to adjust both the volume control of your external device and the volume control of this system to find the most desirable volume setting. CARE AND MAINTAINANCE - Do not subject the unit to excessive force, shock, dust or extreme temperature. - Avoid leaving your unit in direct sunlight or in hot, humid or dusty places. - Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. Resetting the Unit If the unit is subject to a power surge or electric shock, it is possible that the internal micro-controller may lock up and the unit will not respond to any commands from the top panel controls or remote control. [. . . ]