User manual JUNO JDK8460W

[. . . ] When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please , keep to the provisions of official directives regarding the question of fume discharge. [. . . ] Fix the hood definitively with two washers (7) and two screws 5x45 mm (8). For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. Mount the connector ring onto the hole in the hood with two 3, 5x9, 5 screws (9a). Fasten the support for the telescopic chimney (11) with the three screw anchors (10) and the three 5x45 screws (12). Exhausting version: fasten a ventilation duct, which is long enough to reach the outside (13), to the connector ring (9a). Recirculation version: mount the deflector onto the telescopic chimney support with two 2, 9x9, 5 screws. Insert the adaptor (9b) into the connector ring and then connect the hood to the deflector with the ventilation duct (13). Mount the telescopic chimney (14), fasten it above with two screws (15), slide the bottom part of the telescopic chimney towards the bottom (16) and fasten the hood in place definitively (17). Speed 1 LED Speed 2 LED and grease filter saturation LED (flashes) Speed 3 LED and carbon filter saturation LED (flashes) Intensive speed indicator LED Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button A or button B. [. . . ] D) Fit the new light bulb taking care to ensure its contacts are correctly fitted in the connector. If the lighting fails to work, make sure that the halogen light bulbs have been fitted correctly before contacting the technical assistance service! [. . . ]