User manual JUNO JDL4130W

[. . . ] The hood may be used as follows: The air is conveyed out through a pipe which is connected to the outlet hole A (fig. The air must be vented out by means of a pipe with an internal diameter of 120mm. -- The air is purified through an active carbon filter and returned to the room. [. . . ] -- The best performance of the unit is obtained in the exhaust mode, therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. the hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be 7 When installed, the hood must be not less than 65 cm. -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. After having adjusted the hood for the version required, it may be installed. -- This appliance is designed for fitting in a cabinet or some other support. -- The opening to be made on the bottom of the wall-hung cabinet must correspond with the measurements shown in fig. C) Secure the unit to the cabinet by screwing up screws through holes D (fig. To clean the filter, proceed as follows: a) Open the grill by turning knob C (fig. C) With normal use, the grease filter should be washed once a month in a dishwasher or in warm soapy water and should be left to dry before being refitted. When cleaning the grease filter, we recommend washing the grill too with warm water and soap. [. . . ] Before calling for repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. Before performing any maintenance operation, disconnect the hood from the electricity. To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. [. . . ]