User manual JUNO JKI4438

[. . . ] The glass bottles may break. Child Safety ¥ This appliance is designed to be operated by adults only. ¥ In case of disposal of the appliance, cut off the supply cable as close as possible and make thelock unusable, to prevent children from closing themselves inside the appliances. Environment Protection ¥ This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. [. . . ] ¥ Do not put carbonated liquids (fizzy drinks, etc. ) in the freezing compartment as they may burst. ¥ Once defrosted, food deteriorates rapidly and cannot be refrozen. Freezer compartment Temperature Control ¥ To freeze fresh foods it is not necessary to change the setting of the thermostat knob. ¥ For a quicker freezing operation, turn the thermostat knob to the coldest setting; but remember that, in this condition, the refrigerator compartment temperature might drop below 0¡C. ¥ At the first starting-up or after a period out of use, before putting the products in the compartment, let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal operating position. Interior Accessories Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. 15 Maintenance Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. ¥ When defrosting is completed, dry the interior thoroughly and refit the plug. ¥ Turn the thermostat knob back to the required setting or replace the plug in the power socket. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. Defrosting Refrigerator compartment ¥ Defrosting the refrigerator compartment is automatic. The defrost water drains out through a trough into a container at the back of the appliance, above the motor compressor, where it evaporates. ¥ It is important to periodically clean the defrost water drain hole. Cleaning Never use metal objects for cleaning your appliance as it may get damaged. NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour. To guarantee a safe operation of the fridge, once a year remove the ventilation grille at the base and clean the air channels with a vacuum cleaner. When the appliance is not in use Disconnect the appliance from the electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. D037 Freezer compartment ¥ Remove the frost with a plastic scraper. ¥ Whenever the thickness of the frost exceeds 5 mm complete defrosting should be carried out. The insulation material used has a tendency to slighly increase noise levels, how ever it allows for much better insulation and a lower energy consumption. It is too warm inside the refrigerator It is too cold inside the refrigerator. The compressor works continuously. There is water inside/outside the refrigerator. Noises Customer service and spare parts If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department and consult the Guarantee card. [. . . ] Apply joint the sealing strip as shown in figure. C D PR266 D132 20 6. Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 9. Should the lining up of the furniture door be necessary, use the clearance of slots. [. . . ]