User manual JUNO JKU6435

[. . . ] Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!0 This symbol guides you step by step in the operation of the appliance. [. . . ] This makes it is more difficult to change the temperature setting accidentally (child protection). Turn in the direction of "1": Refrigeration on, the compressor starts and then runs automatically. The following effects are of significance in respect of the interior temperature: ­ Ambient temperature; ­ Quantity and temperature of the food stored; ­ Frequency with which the door is opened and how long it is left open. The following temperature settings can therefore only be considered as recommendations that may well need to be adapted to suit your particular situation. Recommended settings: a) For normal refrigeration without using the freezer compartment: ­ Position "1" to "2"; ­ If lower temperatures are required, position "2" to "3". B) When frozen foods are stored in the freezer compartment or fresh food is to be frozen, a temperature setting of between "2" and "4" should be selected, depending on the ambient temperature. These figures apply at ambient temperatures from +16 °C to +32 °C. At higher ambient temperatures, fresh food is properly frozen with the regulator set to "2" to "3", without the fridge becoming too cold. 0 Turn the temperature regulator to the desired setting with the aid of a coin. On hot summer days) and a cold setting on the temperature regulator (position"3" to "4") can cause the compressor to run continuously. Reason: when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. The fridge will not be able to defrost since automatic defrosting of the fridge is only possible when the compressor is not running (see also "Defrosting" section). If this happens, turn the temperature regulator back to a warmer setting (position "2" to "3"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. 0 To switch off the appliance, turn the temperature regulator to position "0". 0 If the door is to left open for an extended period, switch off the interior lighting by pulling out the oval light switch (holiday switch). The next time the door is opened, the interior lighting is switched on by the light switch as normal. If the appliance is not going to be used for an extended period: Switch off the appliance by turning the temperature regulator to position "0". Remove the mains plug or switch off or turn out the circuit breaker or fuse. defrost freezer compartment and clean thoroughly (see section: "Cleaning and Care"). Your appliance is equipped with one full size and two half size glass storage shelves. The height of the storage shelves can be adjusted: 0 To do this pull the storage shelf forward until it can be swivelled upwards or downwards and removed. [. . . ] Door seal is not air tight (possibly after changing over the hinges). The compressor does not start immediately after changing the temperature setting. Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker. 15 W, fitting: E 14 0 To switch off the appliance, turn the temperature regulator to position "0". [. . . ]