User manual JUNO JMR260B

[. . . ] ⷠTake utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. ⷠThe appliance must not be located close to radiators or gas cookers. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances. [. . . ] The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. Before using the appliance for the first time, wash the interior and all internal accessories with luke-warm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. Do not store warm food or evaporating liquids in the refrigerator; · Do cover or wrap the food, particularly if it has a strong flavour. ⷠPosition food so that air can circulate freely round it. The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Do not pull, move or damage any pipes and /or cables inside the cabinet . Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up u liquid added. The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and pre-treating before freezing. When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket; Remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. [. . . ] Hinge lid a groove that facilates the Also make sure that the appliance removal of this coomponent. Separate parts Ha, Hb, Hc, Hd as shown in the figure Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). Place the small square on the guide again and fix it with the screws supplied. [. . . ]