User manual KENWOOD CAW-OP7810

[. . . ] · When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong rating may cause your unit to malfunction. · To prevent short circuits when replacing a fuse, first disconnect the wiring harness. · During installation, do not use any screws except for the ones provided. [. . . ] When the AUTO indicator is off, manual tuning has been selected, and when it is ON, auto seek tuning has been selected. Local seek refers to auto seek tuning that skips radio frequencies with poor reception. When local seek is on, the LO. S indicator turns on. Turning down the volume all the way turns off the attenuator function. 1 Press the SRC button repeatedly until tuner mode is obtained. "TUnE" is displayed when the tuner mode is selected. 2 Press either the FM or AM button to select the band. Loudness This function amplifies low and high tones when the volume is turned down. Turning Loudness On/Off: Press the LOUD button to switch the loudness on and off. Each time you press the FM button, the band switches between the FM1, FM2 and FM3. Press the AM button to select the MW and LW bands. 3 Each time you press the AUTO button, the mode switches as follows: w Auto seek w AUTO indicator r r ! LO. S indicator !r ! Local seek w Manual 4 · Auto Seek Tuning Press the ¢ button Press the 4 button · Manual Tuning Press the ¢ button Press the 4 button to seek increasing frequencies. to decrease the frequency by one step. NOTE The ST indicator lights up when stereo broadcasts are being received. --7-- Tuner features (See page 5) English Monaural Reception Turn monaural reception on and off. Turning Monaural Reception On/Off: Hold down the MONO button one second or more to turn monaural reception on and off. The MONO indicator lights up when monaural reception is on. Auto Memory Entry You can automatically store all the receivable frequencies in the band currently being listened to, and then recall them with the touch of a button later. The hour display will blink. 3 · Adjusting the hours Press the FM button to advance the hours, or press the AM button to make the hours go back. Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. Take Connector A on the wiring harness and connect it to the external power connector on your vehicle. Press the reset button. 2CAUTION · If your car is not prepared for this special connection-system, consult your kenwood dealer. · Only use antenna conversion adapters (ISO-JASO) when the antenna cord has an ISO plug. · Make sure that all cable connections are securely made by inserting jacks until they lock completely. · If your vehicle's ignition does not have an ACC position, or if the ignition cable is connected to a power source with constant voltage such as a battery cable, the power will not be linked with the ignition (i. e. , it will not turn on and off along with the ignition). If you want to link the unit's power with the ignition, connect the ignition cable to a power source that can be turned on and off with the ignition key. · If the fuse blows, first make sure that the cables have not caused a short circuit, then replace the old fuse with one with the same rating. · Do not let unconnected cables or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits, also do not remove the caps on the ends of the unconnected cables or the terminals. [. . . ] Clean the tape head, referring to the section on "Cleaning the tape head" (see page 3). Reconnect the speaker cables so that each output terminal is connected to a different speaker. Connect the cable correctly, referring to the section on "Connecting Cables to Terminals". Connect the cable correctly, referring to the section on "Connecting Cables to Terminals". [. . . ]