User manual KENWOOD KDC-C20V

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual KENWOOD KDC-C20V. We hope that this KENWOOD KDC-C20V user guide will be useful to you.


KENWOOD KDC-C20V : Download the complete user guide (324 Ko)

Manual abstract: user guide KENWOOD KDC-C20V

Detailed instructions for use are in the User's Guide.

[. . . ] Install the unit as far away as possible from the speakers. • Be sure to use CDs with disc mark only for this unit. VIDEO CD • CD-Rs and CD-RWs which have not undergone finalization processing cannot be played. (For more information on finalization processing, refer to the manual for your CD-R/CD-RW writing software or CD-R/CD-RW recorder. ) Additionally, depending on the recording status, it may prove impossible to play certain CDs recorded on CD-R or CD-RW. Do Not Use CDs with Sticker on the Labeled Side • Do not use the CD with the label sticker stuck on it. [. . . ] The availability of this function as well as the number of discs which can be registered using 2 Stains, scratches, or warping can cause skipping, malfunction, or low sound quality. Take the following precautions to avoid damage to the compact discs. • Avoid touching the recorded side (the side without the titles on) when you hold a compact disc. • The reflective film on a CD-R or a CD-RW is more fragile than that on an ordinary music CD, and may peel off if scratched. Fingerprints on a CD-R or CD-RW are also more likely to cause skipping when the disc is played. Detailed handling instructions will appear on the CD-R or CDRW package: read this information carefully before using the disc. • Do not store discs where they will be exposed to direct sunlight (such as on the seat and dashboard) or high heat. A CD-R or CD-RW is more susceptible than a music CD to damage from high temperatures and humidity, and in some cases, may become unusable if left in the car for long periods of time. • If you do not use your unit for an extended time, remove the discs from the unit and put them in their cases. Do not leave them lying around without cases, piled up, or leaning on a wall and so on. • If you attach an adapter to an 8 cm (3") compact disc and load it into this unit, the adapter may be detached from the disc, causing damage to the unit. Do not use 8 cm (3") compact discs. Installation ■ Accessories A×2 B×4 C×4 D×1 E×1 F×1 G×1 ' ■ Removing the transportation screws Remove all 3 transportation screws for protecting the internal mechanism before you start to install the unit. NOTE After removing the transport screw, retain it carefully and attach it again before transporting the unit again. Transportation screws NTSC / PAL ■ Angle adjustment switches 45 0 Left side Angle adjustment switches S 90 0 45 90 Right side Installation angle V • The angle adjustment switches on the both side of the unit are to be set according to the angle of installation of the CD auto changer. If the switches are not set properly, sound skip or other malfunction may occur. • Set the angle adjustment switches with a coin or other flat object. • Change the switch step by step by detaching and reusing the obdect at the end of each step. 40°~50° 85°~90° 0°~5° Angle adjustment switch position 90 45 0 45 90 0 45 90 0 It is not possible to install at an angle of 40°~50° if only A is used. 3 Installation Use the holes marked ● to install the unit. 2CAUTION Do not tighten the screw B too securely at the time of installation, but tighten it securely after having fixed the bracket A. English ■ Horizontal installation S 0 45 90 Angle adjustment switch position 45 90 0 V 45 90 0 C A 0 45 90 B Ø4 4 ■ Vertical installation S 0 45 90 Angle adjustment switch position 45 90 0 V 45 90 0 C 90 45 A 0 AUX OFF ON B Ø4 ■ In case of hanging in the trunk S Angle adjustment switch position 0 45 90 V 45 45 90 0 0 90 Ø4 A 0 45 90 B C 5 Connections O-N switch English "S" S 45 0 O C S T N / L A P N 45 90 0 V "V" D Changer control cable (5m) NTSC / PAL Changer control terminal "NTSC" "PAL" F Video cable (4m) Monitor unit (optional) Control unit (optional) Picture format selector switch EMultiple audio selector switch (5m) 2CAUTION • Do not connect the changer control cable while the control unit is turned ON. • Do not install an antenna of radio equipment or distribute the antenna cable near the changer output cable, for this could cause malfunction with this unit. ■ Setting the O-N switch Set the O-N switch (lying to the right of the EJECT key) depending on the unit connected, as follows: Control unit Changer switching unit O-N switch setting CD text-capable None N KCA-S210A N Not CD text-capable None O KCA-S210A O KCA-S200 O Consult the instruction manual for your control unit to check whether or not it is CD text capable. That information can be found on the page for External Disc Control in the section concerning switching to "N. " ■ The picture format selector switch must be set to the format of the connected monitor. [. . . ] • Depending on the disc, unwanted noise may be present in the sound. • Depending on the recording status, it may prove impossible to play certain VCDs NOTE The audio output mode switches back to "L + R" when the control unit's source mode is switched or the power is turned off. Troubleshooting Guide PROBLEM The disc changer mode cannot be selected. The specified disc does not play, but another one plays instead. POSSIBLE CAUSE No cable has been connected to the disc changer input terminal on the unit. • The disc is severely scratched. SOLUTION Connect the cable to the disc changer input terminal on the unit. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE KENWOOD KDC-C20V




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual KENWOOD KDC-C20V will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.