User manual KENWOOD KEC-101

[. . . ] Make sure not to get your fingers caught between the faceplate and the unit. Do not touch the liquid crystal fluid if the LCD is damaged or broken due to shock. The liquid crystal fluid may be dangerous to your health or even fatal. If the liquid crystal fluid from the LCD contacts your body or clothing, wash it off with soap immediately. [. . . ] During reception of traffic information the adjusted volume is automatically remembered, and the next time it switches to traffic information it's automatically the remembered volume. This function can't be used during a traffic bulletin or AM reception. Traffic information station switching can be done when listening to the radio. Putting the Program Type in the Preset button memory and calling it up quickly. The Program Type can be put in the [1] -- [6] button memory and called up quickly. When you want to search for other stations press the [4] or [¢] button again. When the selected Program Type isn't found, "No PTY"/ "NO PTY" is displayed. Press the faceplate on the left side, and return it to its former position. When the faceplate has been dropped open, it might interfere with the shift lever or something else. If this happens, pay attention to safety and move the shift lever or take an appropriate action, then operate the unit. If it's used in the open position dust can enter the inside part and cause damage. Because authorization by the Security Code is required when it's removed from the vehicle, personalizing this unit is by using the Security Code is a help in preventing theft. When the Security Code function is activated it can't be released. Note, your Security Code is the 4 digit number entered in your "Car Audio Passport" in this package. when "MENU" is displayed , "Security"/ "SECURITY" is displayed. Enter Security Code mode Press the [4] or [¢] button for at least 1 second. Do the step 4 through 7 step operation, and reenter the security code. If you enter a Code different from your Security Code, you have to start over from step 4. Do the step 4 through 7 step operation, and reenter the security code. After the input prohibited time lapses, "CODE" is displayed, and input can be done. Number of times the incorrect code was input 1 2 3 4 Input prohibited time -- 5 minutes 1 hour 24 hours Press the Reset button and when it's removed from the battery power source Turn the power ON. This adjustment can be done when the <Synchronize Clock> (page 22) is set as OFF. [. . . ] Before calling service, first check the following table for possible problems. After checking for short circuits in the wires, replace the fuse with one with the same rating. If there's no media in this unit, you can't switch to each source. If the Disc changer isn't connected to it's input terminal, You can't switch to an external disc source. [. . . ]