User manual KENWOOD KEC-302

[. . . ] If the unit is installed near speakers, the speakers vibration may causes a sound skip. ⷠCD-Rs and CD-RWs which have not undergone finalization processing cannot be played. (For more information on finalization processing, refer to the manual for your CD-R/CD-RW writing software or CD-R/CD-RW recorder. ) Additionally, depending on the recording status, it may prove impossible to play certain CDs recorded on CD-R or CD-RW. [. . . ] Using such a CD may cause the CD to be deformed and the sticker to peel off, resulting in malfunction of the unit. If you have difficulty in installing this unit in your vehicle, contact your Kenwood dealer. ⷠIf it doesn't seem to be working properly, first press the Reset button. If the front panel is dirty, wipe it clean with a silicon cloth or soft dry cloth with the power off. Do not use hard cloths or paint thinner, alcohol, or other volatile solvents. Note that any control units released in 1997 or earlier cannot be connected to this unit. <KEC-302/C669> The disc name preset function can register names of up to 100 discs using up to 12 characters for each disc name. The availability of this function as well as the number of discs which can be registered using this function and the number of usable characters may be variable depending on the control unit in use. <KDC-C469> The disc name preset feature can store the names of up to 50 discs in memory. The marking of products using lasers (Except for some areas) It means that the unit is using laser beams that are of a weaker class. When removing the CD changer, be sure to first eject a magazine then unplug the changer cord. Do not forget to attach the transport screws before transporting the CD changer. The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport screws are not attached. 2CAUTION · Take care to insert trays into the correct grooves in the disc magazine and to insert discs properly into the tray grooves. ⷠInsert all trays even when some of them do not carry discs. Do not connect the changer control cable while the control unit is turned ON. ⷠBe sure to press the reset button after installation. ⷠDo not install an antenna of radio equipment or distribute the antenna cable near the changer output cable, for this could cause malfunction with this unit. [. . . ] ⷠDo not install an antenna of radio equipment or distribute the antenna cable near the changer output cable, for this could cause malfunction with this unit. Use the CD changer with its door closed to prevent the entry of dust into the changer. If the door is not completely open, the magazine may hit the door and cause damage of malfunction. Pozycja przelcznika regulacji kta It is not possible to install at an angle of 40°~50° if only A is used. [. . . ]