User manual KENWOOD KGC-4042

[. . . ] After the system acquires satellites for the first time, it will acquire satellites quickly each time thereafter. When removing the product from the box or installing it, the front panel may be positioned at the angle shown in (Fig. If the program that is activated when the product is first powered on works properly, the front panel will automatically move into the position (initial setting angle) shown in (Fig. Reception may drop if there are metal objects near the Bluetooth antenna. [. . . ] Reception may drop if there are metal objects near the Bluetooth antenna. For safety's sake, leave the mounting and wiring work to professionals. â· Make sure to ground the unit to a negative 12V DC power supply. â· Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. â· If the power is not turned ON ("PROTECT" is displayed), the speaker wire may have a short-circuit or touched the chassis of the vehicle and the protection function may have been activated. â· Make sure that all wire connections are securely made by inserting jacks until they lock completely. â· If your vehicle's ignition does not have an ACC position, or if the ignition wire is connected to a power source with constant voltage such as a battery wire, the power will not be linked with the ignition (i. If you want to link the unit's power with the ignition, connect the ignition wire to a power source that can be turned on and off with the ignition key. â· Use a commercially available conversion connector if the connector does not fit in the vehicle connector. Please be sure to reconnect the cable as shown 2 below to install this unit to the Volkswagen vehicles etc. 1 (Default setting) The A-7 pin (red) of the vehicle's ISO connector is linked with the ignition, and the A-4 pin (yellow) is connected to the constant power supply. Cut out accessory 6 to meet the shape of the opening of the center console. Fold double-sided adhesive (accessory 7) along the slit and attach it to accessory 6 cut-out against the center rib as illustrated. It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals. Peel the backing off of the adhesive on the bottom of the metal plate (accessory 0). Press the metal plate (accessory 0) down firmly on your dashboard or other mounting surface. Wire the cable up to the unit with it secured at several positions using tape or the like. Depending on the type of car, reception of the GPS satellite signals might not be possible with an inside installation. â· The GPS antenna should be installed at a position that is spaced at least 12 inch (30 cm) from cellular phone or other transmitting antennas. [. . . ] Wire the cable up to the unit with it secured at several positions using tape or the like. Depending on the type of car, reception of the GPS satellite signals might not be possible with an inside installation. â· The GPS antenna should be installed at a position that is spaced at least 12 inch (30 cm) from cellular phone or other transmitting antennas. Signals from the GPS satellite may be interfered with by these types of communication. [. . . ]