User manual KENWOOD KGC-6042

[. . . ] Before applying the power Caution : Read this page carefully to ensure safe operation. How to use this manual This manual is divided into four sections, Preparations, Operations, Remote Control, and Additional Information. Shows you how to connect your audio and video components to the receiver and prepare the surround processor. Since this receiver works with all of your audio and video components, we will guide you in setting up your system to be as easy as possible. [. . . ] 2 Turn on the power to this receiver by pressing POWER ON/ OFF and ON/STANDBY key. If you have selected a component connected to the CD/DVD, VIDEO2, DVD/6CH jacks, make sure that the input mode setting is correct for the type of audio signal to be used. You can adjust the Loudness function which controls the low volume settings to maintain the music's richness. The adjustment can be made when the receiver is in the PCM stereo and analog stereo mode. Press the Loudness key again so that the "LOUDNESS" indicator goes off. Press the MUTE key again so that the "MUTE" indicator goes off. You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode. 1 For the remote control, press and hold the TUNER key for more than 3 seconds to switch to receiver mode. You can enjoy a more impressive sound effect when ACTIVE EQ is turned ON during Dolby Digital and DTS playback and, when in PCM and analog stereo mode. Press the ACTIVE EQ key for the following selections; 1 ACTIVE EQ MUSIC : Effective when listening to music. ACTIVE EQ function will not be available when REC MODE, AUTO TUNING or PRESET MEMORY is ON and during 96kHz LPCM playback. Before using a function utilizing the RDS, be sure to perform the RDS Auto Memory operation by referring to the description in "Presetting RDS stations (RDS AUTO MEMORY)". Each press switches the tuning method as follows: 1 AUTO lit (auto tuning) "AUTO" indicator lights 2 AUTO not lit (manual tuning) up in the display. The RDS auto memory function assigns preset numbers to RDS stations starting from preset number "1". Therefore, be sure to execute the RDS auto memory function before using the following operaptions to manually store AM stations and other FM stations, and RDS stations. If the radio waves are weak and there is a lot of interference, switch to manual tuning. Blinks for 5 seconds Lights for 5 seconds Call @¥# keys to select the desired station. Each time you press the key, another preset station is received in order. Call @ does the following: Call # or @ key, lets you skip through the presets, receiving each preset station at 0. If you store a station at a previously used preset, the previous station will be replaced by the new one. 2Enter the number of the preset station you want to receive (up to "40"). Press the numeric keys in the following order: For "15", press . [. . . ] For that reason, we have programmed extra functions on some of the unused number keys to help you control your equipment. The microcomputer may malfunction (unit cannot be operated, or shows an erroneous display) if the power cord is unplugged while the power is ON, or due to some other external factor. If this happens, execute the following procedure to reset the microcomputer and return the unit to its normal operating condition. For other countries With the power cord plugged in, turn the POWER ON/ OFF key OFF. [. . . ]