User manual KENWOOD KRC-3005

[. . . ] · When extending the ignition, battery, or ground wires, make sure to use automotivegrade wires or other wires with a 0. 75mm2 (AWG18) or more to prevent wire deterioration and damage to the wire coating. · To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. · If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. · Make sure not to get your fingers caught between the faceplate and the unit. [. . . ] Enter Audio Control mode Press the [A. ADJ] button for at least 1 second. Each time the button is pressed the items that can be adjusted switch as shown below. Adjust the Audio item Press the [4] or [¢] button. ec4 (Sound Coordinate) You can recall the best sound setting preset for different types of the music. 4 1 Select the source to set Press the [SRC] button. --6-- Adjustment Item Bass level Treble level Balance Fader Display "BAS" "TRE" "BL" "FD" Range ­4 -- 4 ­4 -- 4 L15 -- R15 R15 -- F15 Theft Deterrent Faceplate The faceplate of the unit can be detached and taken with you, helping to deter theft. The faceplate is unlocked, allowing you to detach it. · The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special storage case while detached. · Do not expose the faceplate or its storage case to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. 5 Exit Audio Control mode Press the [A. ADJ] button. Switching Clock Display Switching the displayed information. Each time the button is pressed it switches between clock display and current source. During clock display the clock indicator is ON. Reattaching the Faceplate 1 Align the projections on the unit with the grooves on the faceplate. Adjusting Clock 1 2 Select the clock display Press the [CLK] button. Enter clock adjustment mode Press the [CLK] button for at least 2 seconds. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. Connect the wiring harness wires in the following order: ground, battery, ignition. Press the reset button. · If your car's ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die. · If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. · If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. · Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. · Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car. · When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). [. . . ] After checking for short circuits in the wires, replace the fuse with one with the same rating. If there's no media in this unit, you can't switch to each source. If the Disc changer isn't connected to it's input terminal, You can't switch to an external disc source. Reattach the faceplate correctly, See the section on <Removing the Faceplate>(page 7). [. . . ]