User manual KENWOOD LZ-700W

[. . . ] When the temperature of the unit falls such as during winter, the liquid crystal panel's screen will become darker than usual. Products with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment should be recycled at a facility capable of handling these items and their waste byproducts. contact your local authority for details in locating a recycle facility nearest to you. [. . . ] Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment. The illustrations of the display and the panel appearing in this manual are examples used to explain more clearly how the controls are used. Therefore, what appears on the display in the illustrations may differ from what appears on the display on the actual equipment, and some of the illustrations on the display may represent something impossible in actual operation. If the faceplate of this unit is stained, wipe it with a dry soft cloth such as a silicon cloth. If the faceplate is stained badly, wipe the stain off with a cloth moistened with neutral cleaner, then wipe it again with a clean soft dry cloth. Applying spray cleaner directly to the unit may affect its mechanical parts. Wiping the faceplate with a hard cloth or using a volatile liquid such as thinner or alcohol may scratch the surface or erases characters. Each time the button is pressed, the screen mode switches as follows: Display "Full" Setting Full picture mode. Each time the button is pressed for at least 1 second, the audio input switches as follows: Display "Normal" "AV-IN1" "AV-IN2" "Off" Setting Sound with monitor source. If you connect the ignition wire to a power source that receives a constant voltage supply, as with battery wires, the battery may die. If the fuse blows, first make sure that the wires have not caused a short circuit, then replace the old fuse with one with the same rating. Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits do not remove the caps from unused terminals or from the ends of the unconnected wires. After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. Thoroughly wipe away oil and other dirt from the installation surface. For safety's sake, leave the mounting and wiring work to professionals. Using the supplied paper pattern (Accessory 5), mark the area to be cut out of the headrest, then carefully cut it. Use screws (Accessory 3) to fix Hideaway Unit onto an audio board or another. [. . . ] Using the supplied paper pattern (Accessory 5), mark the area to be cut out of the headrest, then carefully cut it. Use screws (Accessory 3) to fix Hideaway Unit onto an audio board or another. What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. [. . . ]