User manual KENWOOD LZ-702W

[. . . ] Using a fuse with the wrong rating may cause your unit to malfunction. To enjoy video pictures, find a safe place to park and engage the parking brake. If you experience problems during installation, consult your Kenwood dealer. When you purchase optional accessories, check with your Kenwood dealer to make sure that they work with your model and in your area. [. . . ] The "TIN" and "COL" cannot be adjusted for the navigation picture (RGB) or the control screen. The reference for the Menu items and their setting content is after this operation explanation. If you cannot select a setup menu item, press the [MENU] button, the touch panel position settings are reset to the factory defaults. If you make no operation for 15 seconds, this mode is automatically canceled. SEL] button when the image from the device connected to "AV2 INPUT" terminal is shown on the monitor. Use this setting when there's nothing connected to the "AV2 INPUT" terminal. SEL] button when the image from the navigation unit connected to "TO NAVIGATION" terminal is shown on the monitor. SEL] button when the image from the navigation unit connected to "AV1 INPUT" terminal is shown on the monitor. Use this setting when there's nothing connected to the navigation unit. Item Touch "Reverse" [7On] Setting Switches to the rear view camera video display when engaging the shift knob of car to "Reverse". Switches to the rear view camera video display when engaging the shift knob of car to "Reverse" and then pressing the [V. The image which appeares in the camera is turned left-side right and displayed. Touch the [Yes] button, restores the factory set default values for individual items from those set by the user. The touch panel can be adjusted if the position touched and the operation performed do not match. If the [Cancel] button is touched without touching the button at the lower left, the adjustment is canceled and the screen goes back to the Setup Menu Screen. If the [Cancel] button is touched after touching the button at the lower left, the button at the lower left reappears. If the [Reset] button is touched, the settings are reset to the factory defaults and the setup menu screen reappears. To prevent short circuits, remove the key from the ignition and disconnect the · Make the proper input and output cable connections for each unit. Connect the wiring harness wires in the following order: ground, ignition. This product is intended for use with 12V DC negative ground power only. To prevent shorting, disconnect the battery cable from the negative terminal of the battery during installation. Follow the installation and wiring procedures described in this manual. [. . . ] Using the supplied paper pattern, mark the area to be cut out of the headrest, then carefully cut it. Use screws (Accessory 6) to fix Hideaway Unit onto an audio board or another. 2 Pull the monitor unit all the way out with your Hands, being careful not to drop it. What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. [. . . ]