User manual KENWOOD LZ-760R annexe 1

[. . . ] The liquid crystal fluid may be dangerous to your health or even fatal. If the liquid crystal fluid from the LCD contacts your body or clothing, wash it off with soap immediately. 2CAUTION Applying spray cleaner directly to the unit may affect its mechanical parts. Wiping the faceplate with a hard cloth or using a volatile liquid such as thinner or alcohol may scratch the surface or erases characters. Screen brightness during low temperatures When the temperature of the unit falls such as during winter, the liquid crystal panel's screen will become darker than usual. Normal brightness will return after using the monitor for a while. To prevent damage to the machine, take the following precautions: · Make sure to ground the unit to a negative 12V DC power supply. [. . . ] Selecting the Reception Area: Each time you touch the [ 2 ] or [ 3 ] button. G1 G2 China Burnei Malaysia Singapore Thailand Hong Kong Indonesia Australia PAL-D PAL-B/G Exit the System Setup Screen-2 Touch the [Return] button. Return to the setup menu screen. G3 G4 G5 PAL-I PAL-B/G · The reception area can be set for two separate preset bands TV1 and TV2. Exit the TV Area Setting Screen Touch the [Return] button. Return to the Setup menu screen. · Pulling out the Connection cable to the TV tuner, settings of the TV Area will be default. Press the Reset button and set the TV Area again if the Connection cable is reconnected. English | 11 < Touch Panel Adjustment > Before Use Touch Panel Adjustment Screen Adjusting the Touch Position The touch panel can be adjusted if the position touched and the operation performed do not match. 1 Accurately touch the mark at the lower left. 2 Accurately touch the mark at the upper right. When the mark at the upper right is touched, the adjustment is completed and the system setup menu screen reappears. · If the [Cancel] button is touched without touching the button at the lower left, the adjustment is canceled and the screen goes back to the Setup Menu Screen. · If the [Cancel] button is touched after touching the button at the lower left, the button at the lower left reappears. · If the [Reset] button is touched, the settings are reset to the factory defaults and the setup menu screen reappears. 12 | English Setup Function English | 13 TV Control Before Use Function (During the KTC-V500P is connected) On Screen Control A E D B C Control Screen Selecting the Preset Band Switching the Control Screen Touch the D area. Each time the button is touched the preset band switches between the TV1 and TV2. Seek Mode Sets the seeking mode. Each time the button is touched the seeking mode switches as shown below. Seeking mode(display) Auto seek ("Auto1") Preset station seek ("Auto2") Manual ("Manual") Operation Automatic search for a station. Normal manual seeking control. · If you make no button operation for 10 seconds, the control screen is automatically cancelled. Selecting the Preset Band Touch the B area. Each time the B area is touched the preset band switches between the TV1 and TV2. · If the button is not operated for 5 seconds, the Seek, Band, and Ch indications disappear automatically. Seek Mode Sets the seeking mode. When the seek button is displayed, touching the A area switches the seeking mode as follows: Seeking mode(display) Auto seek ("Auto1") Preset station seek ("Auto2") Manual ("Manual") Operation Automatic search for a station. Normal manual seeking control. Selecting the Channel Touch the [4] or [¢] button. Selecting the Channel Touch the A, E or C area. 14 | English Station Preset Memory Putting the station in the memory. 2 Select the channel to put in the memory Touch the [4] or [¢] button. 3 Put the channel in the memory Touch the [P1] -- [P8] button for at least 1 seconds. On each band, 1 station can be put in the memory on each [P1] -- [P8] button. Exit the Control Screen Touch the [OK] button. · If you make no button operation for 10 seconds, the control screen is automatically cancelled. Auto Memory Entry Putting stations with good reception in the memory automatically. When 8 stations that can be received are put in the memory Auto Memory Entry closes. · If you make no button operation for 10 seconds, the Auto Memory Entry is automatically cancelled. Recalling a Preset Station 1 Select the band 2 Call up the station Touch the [P1] -- [P8] button. English | 15 Installation Accessories A F (M4 x 8 mm) . . . . . . . . . . 1 B G . . . . . . . . . . 4 . . . . . . . . . . 1 C H (Ø4 x 12 mm) . . . . . . . . . . 5 . . . . . . . . . . 2 D I . . . . . . . . . . 2 . . . . . . . . . . 1 E J . . . . . . . . . . 2 (Ø4 x 16 mm) . . . . . . . . . . 4 . . . . . . . . . . 1 The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above. 16 | English Installation Procedure 1. To prevent short circuits, remove the key from the ignition and disconnect the · terminal of the battery. Connect the wiring harness wires in the following order: ground, battery, ignition. [. . . ] 7. 0 inches wide 154. 1(W) x 87. 0(H) x 177. 0(Diagonal) mm Display system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Transparent TN LCD panel Drive system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TFT active matrix system Number of pixels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 336, 960 pixels (480 H x 234 V x RGB) Effective pixels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 99. 99% Pixel arrangement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RGB striped arrangement Back lighting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cold cathode tube Speaker power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 5 W (40 x 20 mm x 1) Video Box Unit Colour system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]