User manual KENWOOD R-SE7

[. . . ] FM/AM RECEIVER R-SE7 DP-SE7 X-SE7 CD PLAYER CASSETTE TAPE DECK INSTRUCTION MANUAL KENWOOD CORPORATION COMPACT DIGITAL AUDIO B60-3330-00 JA (T) AP WS 98/12 11 10 9 8 7 6 5 4 3 2 1 97/12 11 10 9 8 7 6 5 2 Before applying power Caution : Read this page carefully toBefore applying power ensure safe operation. R-SE7/DP-SE7/X-SE7 (En) Units are designed for operation as follows. AC 120 V only For the United Kingdom Factory fitted moulded mains plug 1. The mains plug contains a fuse. 2. The fuse cover must be refitted when replacing the fuse in the moulded plug. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or adapter, or consult your dealer. [. . . ] Select a station. When no stations have been memorized tuning 2 Knowledge sections Remote control unit 4 P. CALL ¢ Auto tuning : Each press receives the next station. Manual tuning : Press the key repeatedly or hold it depressed until a station is received. When stations have been memorized (preset call) Every time the key is pressed, the preset stations are switched over as follows. 3=2=1=40. . . Select a station Hearing sound 27 R-SE7/DP-SE7/X-SE7 (En) Collective presetting of stations (auto preset) 1 Receive a FM broadcast. 2 Keep the "enter" key depressed (for 2 sec or enter more). During recording, the indicator "A MEMO" flashes. ÷ Up to 30 stations can be memorized. ÷ For use of the RDS function, stations must be memorized by RDS auto presetting. If there is memory left after presetting, the receiver continues presetting regular FM stations. AUTO One-by-one presetting (manual preset) 1 Press the "enter" key during reception. enter A MEMO Preparation section Presetting is cancelled when no operation is executed for 5 seconds or more. ÷ For memorizing of stations other than RDS stations (FM, AM), memorize the stations according to chapter "Oneby-one presetting (manual preset)". TUNED 2 Select one of the preset numbers from 1 to 40. Presetting is cancelled when no operation is executed for 5 seconds or more. volume control pure A )AUTO ST. MHz Goes off 3 Press the "enter" key again. enter ÷ Repeat steps 123 to preset other stations. ÷ If several stations are preset under the same number, the previous memory is replaced with the latest memory contents. )3 8 9 . ) ) MHz Basic section R-SE7 AUTO Select the tuning mode. auto/mono Each press alternates the mode. 1"AUTO" lit (Auto tuning) 2"AUTO" not lit (Manual tuning) FM 8 8 . ) ) MHz Application section Lights during stereo reception AUTO ST. TUNED Frequency display R-SE7 Use the manual tuning mode when reception is noisy due to weak reception. (In the manual mode, stereo broadcasts are received in monaural. ) FM 8 9 . ) ) ÷ Normally, use the AUTO (Auto tuning) mode. MHz The "TUNED" indicator lights when a station is received. About display change during tuner reception The display will change each time the DISPLAY key is pressed. Knowledge sections ÷ When a key is held depressed, preset stations will be skipped at an interval of about 0. 5 second. ÷ Preset calls also can be made by numerical input via the numeric keys on the remote control. When the key for the tens digit has been pressed erroneously at the time of input, press the +10 key several times to return to the original display and then enter the number again. 1Reception band/Frequency 2Preset number/Frequency 3Clock 28 Recording Note Recording R-SE7/DP-SE7/X-SE7 (En) Recording Note that this cassette deck cannot record onto Metal tapes. 4 Preparation section 3 3 1 5 2 Basic section 0 1. Load a tape in deck. 1 Top side 1 Open the tray of the cassette deck. 3 Close the tray. ÷ Differentiation between normal (TYPE I) and high (TYPE II) tape is set automatically. ÷ Remove tape slack before loading. Application section Reverse side Check the tape transport direction indicator. 2. Select the tape transport direction. To reverse the transport direction 1 Press the playback key for the direction to be played (lights green). 2 Stop playback (lights red). ÷ When recording is started, the tape is transported in the direction selected in this step. ÷ Wind the tape to the position where recording is to be started. 2 Knowledge sections 3 Dolby NR rev. 2 Select the DOLBY NR mode. £ £ Recording 29 R-SE7/DP-SE7/X-SE7 (En) Temporary stop during recording 8 8 An unrecorded section of about 4 sec is produced (auto recording mute) 1 Obtain stop condition. [. . . ] 1. 2 V / 1 k Digital output Optical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ­15 dBm ~ ­21 dBm (wave length 660 nm) Preparation section General Power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . W: 200 mm H: 77 mm D: 249 mm Weight (net) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 2 µV (75 ) / 13. 2 dBf (40 kHz DEV. , S/N 26 dB) Signal to noise ratio (DIN weighted at 1 kHz, 65. 2 dBf input) MONO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]