User manual KENWOOD TK-3360

[. . . ] The use of the warning symbol means the equipment is subject to restrictions of use in certain countries. This equipment requires a licence and is intended for use in the countries as below. We are grateful you have chosen Kenwood for your land moble rado applcatons. Government law prohbts the operaton of unlcensed rado transmtters wthn the terrtores under government control. [. . . ] Acrylic ester, which is contained in these glues, may crack the transceiver's back panel . Note: To keep the transceiver water resistant, you must cover the speaker/ microphone jacks with the supplied cap. While holding the cap in place, push it towards the bottom of the transceiver until the tabs on the cap click into place . To remove the cap, hold the top of the cap in place with your finger while inserting a 3 mm or smaller flat blade screwdriver under the bottom of the cap. Slowly slide the screwdriver in until its tip touches the tab inside the cap, then gently pry the cap up (handle of screwdriver moving away from the transceiver) to remove the cap . Note: The transceiver is not fully water resistant when using a speaker/ microphone or headset . While holding the locking bracket in place, push it towards the bottom of the transceiver until the tabs on the bracket click into place . â· To remove the locking bracket, push the bracket up from the base . There are 3 types of stoppers available, depending on the number of channels used (4 channel type: white, 8 channel type: gray, and 2 channel type: black) . 1 set the selector knob to channel , then pull the selector knob off the transciever . If the selector is not positioned at channel , the selector knob may not install correctly and the channel may be unable to be changed . Power switch/ Volume control rotate to turn the transceiver on/oFF and to adjust the volume . Transmit/ Receive/ Battery low indicator If enabled by your dealer, lights red while transmitting, green while receiving a call, and orange or blue (depending on dealer programming) when receiving an optional signaling call (5-tone, dtmF signaling, etc . Auxiliary key press or hold to activate its programmable function {page 8} . PTT (Push-To-Talk) switch Press and hold this switch, then speak into the microphone to call a station . Side 1 key press or hold to activate its programmable function {page 8} . Side 2 key press or hold to activate its programmable function {page 8} . speaker/ microphone jack connect a speaker/ microphone or headset here {page 5} . Your dealer can program the Auxiliary, Side 1, and Side 2 keys each with 1 or 2 of the following functions. Because each key can be programmed with up to 2 functions, there are 2 methods of accessing the programmed functions . Functions can be accessed by either pressing the key or by pressing and holding the key . If an event occurs while Activity Detection is enabled, the transceiver enters emergency mode . [. . . ] If transpond for 5-tone signaling is programmed, an acknowledgement signal is returned to the calling station. If Call Alert for 5-tone Signaling is programmed, an alert tone will sound when the correct tones are received. With the transceiver power off, press and hold the Side 1 key for 2 seconds while turning the transceiver power ON. Press the Side 1 key to increase the Vox gain level, and the Side 2 key to decrease the level . [. . . ]